| Name of works | Vehicle mileage, thousand km | Description page on this site | |||||||
| 3 | 15 | 30 | 45 | 60 | 75 | 90 | 115 | ||
| Engine | |||||||||
| Check for any extraneous knocks or engine noises Check the coolant level and the tightness of the cooling system, as well as the condition of the hoses and connections Check the tightness of the fuel system, the condition of the hoses and connections of the fuel system Tighten the engine mounts Check the exhaust system for leaks Check and adjust the timing belt tension Replace the timing belt Adjust the timing belt clearances Replace the oil filter, oil in the engine crankcase and check the oil level Replace the coolant Check the condition and adjust the tension of the air conditioning compressor belt Check the condition of the air conditioning system bolt connections Tighten the cylinder head cover fasteners Replace the air filter element Replace the spark plugs Replace the fuel filter Check the toxicity of exhaust gases and, if not in compliance with the standards, eliminate the malfunction Check the functionality of the electronic engine management system using the "CHECK ENGINE" warning light and the absence of fault codes in the controller memory Check the functionality of the air conditioning system | + - - + - - - + + - + + + - - - + + + | + + + - + + - - + - + + - - - - + + + | + + + + + + - - + - + + - + + + + + + | + + + - + + - + + - + + - - - - + + + | + + + + + + - - + + + + - + + + + + + | - - - - - - + - + - + + - - - - + + + | + + + + + + - + + - + + - + + + + + + | + + + - + + - - + - + + - - - - + + + | see Section 3 see Section 3 see Section 3 see Section 4 engine see Section 4 exhaust system see Section 4 timing belt tension see Section 4 timing belt replacement see Section 4 valve adjustment see Section 4 oil and filter change see Section 4 coolant replacement -* -* see Section 4 engine see air filter replacement see replacing spark plugs see fuel filter replacement -* see Section 9 ECM (Electronic Engine Management System(fuel injection system)) -* |
| Transmission | |||||||||
| Check for any extraneous knocks or noises from the clutch and front wheel drives Check the clutch pedal travel and gear shift clarity Check the gearbox oil level and its tightness Check the condition of the wheel drives, gearbox drive rods and the condition of the torque converter Tighten the transmission mounting points Change the gearbox oil | + + - - + - | + + + + - - | + + + + + - | + + + + - - | + + + + + - | + + + + - + | + + + + + - | + + + + - - | see Section 3 see Section 5, see Section 5 see Section 2 see Section 5, see Section 6 see Section 4 see Section 5 |
| Chassis of the car | |||||||||
| Check for deformation, condition of front and rear suspension elements, silent blocks and dust boots of suspension elements Tighten the front and rear suspension mounting points Check the front wheel alignment and adjust it Check the condition of the wheels and tires, balance the wheels and rearrange them according to the diagram shown in the figure 2.1 | - + + - | + - - - | + + + + | + - - - | + + + + | + - - - | + + + + | + - - - | see Section 6 see Section 6 see Section 6 see Section 2 |
| Steering | |||||||||
| Check the functionality of the steering column locking devices Check the condition of the steering rod joints, their protective caps and the condition of the steering gear boots Check the serviceability of the electromechanical power steering Check the steering play | + - + - | + + + + | + + + + | + + + + | + + + + | + + + + | + + + + | + + + + | see Section 7 see Section 7 see Section 7 see Section 9 see Section 7 |
| Brake system | |||||||||
| Check the brake fluid level and the operation of the alarm when the level is low, the condition of the hoses and tubes, the tightness of the hydraulic brake drive Check the functionality of the parking brake lever locking devices Check the condition of the front brake pads, dust boots and grease on the front brake guide pins Check the condition of the rear brake pads, dust boots and the tightness of the working brake cylinders Check the condition of the parking brake cables and adjust the parking brake system Replace brake fluid** Check: brake light switch position; performance of the brake booster and rear wheel brake pressure regulator; braking efficiency of the service and parking brake systems for compliance with standards | + + - - - - + | + + + + + - + | + + + + + - + | + + + + + + + | + + + + + - + | + + + + + - + | + + + + + - + | + + + + + + + | see Section 2 see Section 8 see Section 8 see Section 8 see Section 8 see Section 8 see Section 8 see Section 8 see Section 8 see Section 8 |
| Electrical equipment | |||||||||
| Check for any signs of short circuits or visible damage to the wire insulation Check the functionality of the electrical equipment units: generator, lighting, light and sound alarm, heater, control devices, windshield and headlight wipers, rear window and front seat heating, washers, headlight beam corrector, electric window lifters and outside mirrors, electric locks Check the condition and tension of the alternator drive belt Clean and lubricate the battery terminals and clamps. Check the reliability of the terminal fastening Check the level and density of electrolyte in the battery, bring them up to standard Clean the starter collector, clean and lubricate the starter drive parts, check the wear and fit of the brushes Check: compliance with established standards of the boundaries of the light beams and the total luminous intensity of the headlights, adjust them if necessary; the luminous intensity of the lighting devices and the frequency of flashing of the direction indicators | + + + - - - + | + + + - + - + | + + + + + - + | + + + - + + + | + + + + + - + | + + + - + - + | + + + + + + + | + + + - + - + | - see Section 9 see Section 9 see Section 9 see Section 9 see Section 9 see Section 9 see Section 9 see Section 9 see Section 9 |
| Body | |||||||||
| Check for chips, cracks and corrosion of the paintwork, damage to the mastic of the wheel arches and the underbody Check the functionality of the door locks, hood, trunk lid, as well as the seat mechanisms and seat belts Replace the cabin air filter Clean the drainage holes of the doors and thresholds Lubricate the rubbing areas of the door stops and axles, the hinges and springs of the fuel filler flap, the keyholes of the doors and the trunk lid | - - - + + | + + - + + | + + + + + | + + - + + | + + + + + | + + - + + | + + + + + | + + - + + | - see Section 10 see Section 10 - - |
| *Not described on the website, work should be performed at a specialized car service. **Or after 3 years, whichever comes first. | |||||||||
Full article on the website: ladaman