Vehicle starting and charging system Lada Kalina 1

Battery — care and charging
Features of the battery design The car is equipped with a lead starter battery with a capacity of 55 A•h. Batteries of this capacity are produced by many different manufacturers, but the...

Generator 9402.3701-06 — design features
The vehicles are equipped with a three-phase alternating current generator type 9402.3701-06 with a built-in rectifier unit and an electronic voltage regulator, right-hand rotation (if you look from...

Checking the alternator drive belt tension and replacing it
The alternator drive belt should deflect by 10 mm under a force of 100 N (10 kgf). Otherwise, adjust the alternator belt tension. To check the tension of the alternator drive belt and replace it on...

Removal and installation the alternator drive belt tensioner
To remove and install the alternator drive belt tensioner on a vehicle, you will need a 13 mm wrench. 1. Loosen the alternator drive belt (see " Checking the alternator drive belt tension and...

Removal and installation of generator 9402.3701-06
To remove and install the generator on the car, you will need a 13 mm socket wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Loosen the tension of the generator drive...

itemprop="image"

Generator malfunctions 9402.3701-06
Generator 9402.3701-06 malfunctions, their causes and solutions Cause of malfunction Method of elimination The signal lamp does not light when the ignition is turned on, the control devices do not...

Checking and replacing the voltage regulator with capacitor and brush holder
The generator 9402.3701-06 is equipped with a voltage regulator type 7930.3702B5. The operation of the voltage regulator consists of continuously automatically changing the excitation current of the...

Repair (check, disassembly) of generator 9402.3701-06
To repair the 9402.3701-06 generator on a car, you will need: an ohmmeter, flat- and Phillips-head screwdrivers, 8 and 12 mm wrenches, 8 and 24 mm socket wrenches, and a hammer. 1. Remove the...

Design features, description and device of the starter
The cars are equipped with a starter 2110-3708010 (5702.3708) or a starter from Bosch 0 001 108 203, similar in installation dimensions and technical characteristics. The parts of these starters are...

Removal and installation the starter
To remove and install the starter on a car, you will need: a 13 mm socket wrench, a TORX T25 socket wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the left engine...

Starter repair 5702.3708 (assembly, disassembly)
To repair the starter (5702.3708), you will need: 10 and 13 mm wrenches, an 8 mm socket wrench (head), Phillips and flat blade screwdrivers, pliers for removing retaining rings, a tubular mandrel,...

itemprop="image"

Starter malfunctions, their causes and solutions
Cause of malfunction Method of elimination When the starter is turned on, the anchor does not rotate, the traction relay does not operate The battery is faulty or completely discharged The battery...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Power devices Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Power devices Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Power devices Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Power devices Lada Largus 1 (2012-2023)

Link to this section in various formats

TEXTHTMLBB Code