Engine cooling and lubrication system Lada Kalina 1

Replacing the coolant
According to the manufacturer's recommendation, the coolant in the car should be replaced after 3 years of operation or 75 thousand km of mileage, whichever comes first. To replace the coolant in...

Replacing engine oil and oil filter
According to the manufacturer's recommendation, the oil in the car's engine should be replaced after 15 thousand kilometers. To change the oil in a car engine, you will need: a 17 mm wrench, a...

Design features of the engine lubrication system
The design of the engine lubrication system on a car is shown in the figure 4.7. The engine lubrication system is combined: the main and connecting rod bearings of the crankshaft and the camshaft...

Removal, installation and repair of the oil pump
The oil pump is removed from the vehicle for repairs when its supply decreases, causing constant low oil pressure in the engine lubrication system, and when oil leaks through the sealing gasket. To...

Features of the design of the engine cooling system
The engine cooling system on the car is liquid (with forced circulation of liquid), sealed, with expansion tank. The cooling system is filled with ethylene glycol based coolant (antifreeze,...

Removal and installation the radiator electric fan with casing
In a car, the electric fan of the radiator of the cooling system is removed to replace its electric motor and before removing the radiator, since the electric fan prevents this. To remove and install...

itemprop="image"

Engine cooling system malfunctions
Engine cooling system malfunctions, their causes and solutions Cause of malfunction Method of elimination The engine gets very hot Low coolant level in the expansion tank Thermostat is faulty...

Replacing the engine cooling system radiator
In a car, the radiator must be replaced if a coolant leak is detected. In a car repair shop with special equipment, the radiator can be checked and repaired. To replace the radiator of the cooling...

Replacing the water pump
The main defects of the water pump are leakage of coolant and wear of the bearing (determined by increased noise during operation). Repairing a water pump installed on a vehicle usually does not lead...

Removal and installation the thermostat
In a car, the need to remove the thermostat and replace it may arise if the engine temperature is unstable: overheating or insufficient warming up. In this case, it is not necessary to completely...

Removal and installation the expansion tank
To remove and install the expansion tank on the car, you will need: a key "for 10" (the end one is more convenient), phillips-head screwdriver. 1. Remove the cap from the expansion tank. Unscrew the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Cooling system Lada Granta 1 (2011-2023, VAZ-2190)
• Power unit: Cooling and lubrication system Lada Priora 1 (2007-2018, VAZ-2170)
• Power unit: Cooling system Lada Vesta 1 (2015-2023, VAZ-2180)
• Power unit: Cooling and lubrication system Lada Largus 1 (2012-2023)
• Power unit: Cooling system Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code