Vehicle lighting and alarm system Lada Kalina 1

Lighting, light and sound signaling — general information
The car is equipped with two headlights with halogen high and low beam lamps. To adjust the direction of the low beam, each headlight has two adjusting screws. They allow you to change the direction...

Lighting control unit — removal and installation
Removal 1. Prepare the vehicle for work and disconnect the wire terminal from the negative terminal of the battery (see " Preparing the car for maintenance and repair "). 2. Open the cover of the...

Headlight unit — light adjustment
To complete the work you will need an assistant, as well as: flat horizontal area (preferably near the wall of a house, fence or gate); 5m tape measure; sheet of cardboard (to cover the headlight...

Headlight — replacing bulbs
Warning! Do not touch the halogen lamp bulbs with your fingers. Work in clean cotton gloves without rubber coating. Greasy fingerprints left on the lamp bulb will reduce its service life several...

Headlight — removal and installation
Note: The work is shown on the left headlight. Removal of the right headlight is performed in a similar manner. For ease of operation of the left headlight, you can remove the battery, and for...

Side turn signal — removal, bulb replacement and installation
Sequence of execution 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). Warning: When removing the pointer, do not apply excessive force to avoid breaking the...

Tail light — replacing bulbs
Sequence of execution 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). Turn off the outside lighting. 2. In the luggage compartment, remove the plugs from the rear...

Tail light — removal and installation
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). Turn off the outside lighting. 2. Under the luggage compartment shelf, through the hole in the upholstery,...

Additional brake light — removal and installation
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Open the trunk door and use a TORX T20 key to unscrew the two screws securing the additional brake...

License Plate Light — Removal, Bulb Replacement and Installation
Two license plate lights are installed under the luggage compartment door trim. Sequence of execution 1. Prepare the car for work (see p. 20. "Preparing the car for maintenance and repair"). Turn off...

Interior light — replacement of lamps, removal and installation
To replace a faulty lamp, simply remove the lampshade diffuser. To replace the individual lighting lamp switch and to clean the contacts of the interior lighting lamp switch, it is necessary to...

Trunk and Glove Compartment Lighting Lamps — Replacement
Sequence of execution 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the lamp from the hole in the left trim of the luggage compartment shelf. If...

Horn — Removal, Adjustment and Replacement
Note: There is an adjustment screw on the horn body, by rotating which you can adjust the sound of the horn. It is more convenient to perform adjustments with an assistant. Removal 1. Remove the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Lighting and signaling Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Lighting and signaling Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Lighting and signaling Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Lighting and signaling Lada Largus 1 (2012-2023)
• Electrical equipment: Lighting and signaling Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code