Vehicle lighting and alarm system Lada Priora 1

Features of the design of headlights and lighting
Headlights Lada Priora cars use block headlights that combine low and high beam headlights (with single-filament lamps), as well as direction indicators. In addition, the headlights contain parking...

Possible malfunctions of lighting and light signaling
Possible malfunctions of lighting and light signaling, their causes and methods of elimination

Replacing lamps in lighting fixtures
Note: For proper operation of lighting and light signalling, use the lamps specified in Appendix 6. Attention! Before replacing bulbs in vehicle lighting devices, disconnect the wire from the...

Headlight replacement
You will need: a 10 mm spanner and a Phillips-head screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see "Removing and installing the front...

Replacing the side turn signal light
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the mudguard liner (see "Removing and installing the mudguard and protective wing cover" ). 3. Move the light forward… 4....

Replacing the rear light
1. Disconnect the wire from the negative terminal of the battery. 2. Fold back the trunk trim behind the taillight. 3. Squeeze the clamps… 4. …and disconnect the rear wiring harness connector from...

Replacing an additional brake light
You will need a Phillips-head screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Disconnect the rear wiring harness connector and the additional brake light wires, and...

Replacing the license plate light
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the trunk lid lock trim (see "Removing and installing the trunk lid lock and its drive" ). 3. Unscrew the four nuts...

Removal and installation the interior light
The interior light is removed to replace faulty bulbs and the light switch. You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry up the...

Replacement of control unit for external lighting and instrument lighting
You will need a Phillips-head screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the fuse and relay box cover (see "Replacing fuses and relays in the mounting...

Checking and replacing steering column switches
The steering column switch assembly consists of a connector secured with a clamp to the steering gear shaft bracket and two switches with levers. The left switch turns on the turn signals and...

Removal, installation and adjustment of the horn
The Lada Priora cars are equipped with a sound signal of type 20.3721. Figure 10.9. Sound signal connection diagram: 1 – mounting block; 2 – Sound signal switch; 3 – sound signal; A – to the main...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Lighting and signaling Lada Kalina Hatchback (2004-2013, VAZ-1119)
• Electrical equipment: Lighting and signaling Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Lighting and signaling Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Lighting and signaling Lada Largus 1 (2012-2023)
• Electrical equipment: Lighting and signaling Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code