Car steering Lada Priora 1

Features of the steering design
Steering is trauma-safe, with rack and pinion steering, electric power steering, height-adjustable steering column (angle of inclination), and a damping element on the steering wheel. Figure 8.1....

Possible steering malfunctions
Possible steering malfunctions, their causes and solutions

Removal and installation the steering wheel
You will need: a 24 "socket wrench (head), a flat-bladed screwdriver, and a 5" hex key. 1. Disconnect the wire from the negative terminal of the battery. 2. Set the steering wheel to a position...

Removal and installation of electromechanical power steering
You will need: a Phillips-head screwdriver, 8 mm and 13 mm wrenches (two), and a 13 mm socket wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the steering wheel...

Removal and installation the steering cardan shaft
You will need: a flat-blade screwdriver, a 13 mm wrench (two). 1. Unscrew the nut… 2. …and remove the bolt of the clamp that holds the upper and lower hinges together. 3. Mark the position of the...

Outer Tie Rod End and Ball Joint Boot Replacement
If the steering wheel free play is increased, check the axial and radial clearances in the ball joints of the steering rods. If there is any looseness in the joint or corrosion has appeared on the...

Removal and installation the inner tie rod end
You will need: a flat-blade screwdriver, 13 and 15 mm wrenches. 1. Remove the outer tie rod end (see "Removing and installing the outer tie rod end and replacing the ball joint protective boot" ). 2....

Removal and installation the steering gear
You will need: a flat-blade screwdriver, a knife, and a 13 mm wrench. 1. Remove both front wheels. 2. With the steering wheel in the straight-ahead position, unscrew the bolt from the inside of the...

itemprop="image"

Checking the gap between the rack stop and the stop nut
1. Remove the steering gear from the vehicle (see "Removal and installation of the steering gear" ). 2. Set the rack to the middle position, which is determined by the size (87±0.25) mm from the gear...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Chassis (running gear): Steering Lada Kalina Sedan (2004-2013, VAZ-1118)
• Chassis (running gear): Steering Lada Granta 1 (2011-2023, VAZ-2190)
• Chassis (running gear): Steering Lada Vesta 1 (2015-2023, VAZ-2180)
• Chassis (running gear): Steering Lada Largus 1 (2012-2023)
• Chassis (running gear): Steering Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code