Engine cooling and lubrication system Lada Priora 1

Design features of the engine lubrication system
Figure 5.15. Lubrication system: 1 – oil filter; 2 – oil filter nipple; 3 – pressure reducing valve; 4 – oil dipstick; 5 – cylinder head cover; 6 – oil filler cap; 7 – oil pressure emergency drop...

Removal and installation the oil pump
The oil pump is removed for repair when its supply decreases, causing a constant drop in oil pressure in the engine lubrication system, and when oil leaks through the sealing gasket. You will need:...

Oil pump repair
You will need: a 10 mm wrench, 5 mm and 8 mm Allen keys, two screwdrivers, a caliper, and a micrometer. 1. Remove the oil pump from the vehicle (see "Removing and installing the oil pump" ). 2. Using...

Features of the design of the engine cooling system
Engine cooling system liquid (with forced circulation of liquid), sealed, with expansion tank. The system is filled with ethylene glycol based coolant (antifreeze), non-freezing at ambient...

Possible malfunctions of the cooling system
Possible malfunctions of the cooling system, their causes and methods of elimination

Replacing the expansion tank
You will need a Phillips-head screwdriver. 1. Remove the cap from the expansion tank. Unscrew the drain plug at the bottom of the right radiator tank and drain the fluid from it (see "Replacing the...

Removal and installation the radiator electric fan with casing
The electric fan of the cooling system radiator is removed to replace its electric motor and before removing the radiator, since the electric fan prevents this. You will need the "by 10" key (a...

Replacing the cooling system radiator
The radiator must be replaced if coolant leaks are detected. In a workshop with special equipment, the radiator can be checked and repaired. You will need: key "for 10" (a socket head is more...

Replacing the water pump
The main defects of the water pump are leakage of coolant and wear of the bearing (determined by increased noise during operation). Repairing a water pump usually does not lead to the desired result,...

Replacing the cooling system thermostat
The need to remove the thermostat and replace it may arise when the engine temperature is unstable: overheating or insufficient heating. In this case, it is not necessary to completely drain the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Cooling and lubrication system Lada Kalina Sedan (2004-2013, VAZ-1118)
• Power unit: Cooling system Lada Granta 1 (2011-2023, VAZ-2190)
• Power unit: Cooling system Lada Vesta 1 (2015-2023, VAZ-2180)
• Power unit: Cooling and lubrication system Lada Largus 1 (2012-2023)
• Power unit: Cooling system Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code