Steering Reference Data Table 11.1. Basic data for control, adjustment and maintenance Play in the steering (Steering wheel free play in straight ahead position, measured at steering wheel rim), no more, degrees (mm) 5 (18)...
Description of the steering structure Steering: 1 - tie rod end; 2 - adjusting threaded insert; 3. 6 - brackets for fastening the steering mechanism; 4, 5 - steering rods; 7 - right protective cap: 8 - right support of the steering...
Checking the technical condition of the steering An assistant is required to complete the work. Execution sequence 1. We prepare the car for work (« Preparing the car for maintenance and repair »). 2. Visually check the condition of the protective...
Steering wheel — removal and installation Comment. The work is shown on a car equipped with an airbag. On a car without an airbag, the work is easier, you only need to remove the steering wheel pad. To complete the job, you will need a...
Decorative overlays of a steering column — removal and installation Removing 1. We prepare the car for work (« Preparing the car for maintenance and repair »). 2. On both sides of the steering column, use a Phillips screwdriver to unscrew the two screws... With the...
Tie Rod End — Replacement You will need a ball joint puller to do the job. Removing 1. We prepare the car for work (« Preparing the car for maintenance and repair »). 2. Remove the front wheel (« Wheel - replacement »). 3....
Tie rod — removal and installation Comment. The section shows the removal of the left tie rod. We remove the right thrust in the same way. To perform the work, a viewing ditch or overpass is required. Removing 1. We prepare the car...
Steering Gear Protector — Replacement To perform the work, you will need new plastic clamps for securing the protective cover of the steering mechanism. Removing 1. Disconnect the intermediate shaft of the steering column from the...
Steering column — removal and installation Comment. Depending on the purpose of the work, the steering column can be removed as an assembly with the steering wheel and steering column switches. The work is shown with partial dismantling of...
Steering gear — removal and installation An assistant is required to complete the work. Removing 1. Disconnect the tie rod ends from the levers of the front suspension struts (« Tie Rod End - Replacement »). Warning! On vehicles with an...