Electric Power Devices Lada Granta 1

Battery — Removal and Installation
Removal 1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (" Preparing the car for maintenance and repair "). Similarly, we disconnect the wire...

Battery — Maintenance
Note: There are rechargeable batteries available for sale. These batteries have holes for adding water and checking the density of the electrolyte. To complete the work you will need: fine-grained...

itemprop="image"

Description of the generator design
The vehicle is equipped with a three-phase alternating current generator with electromagnetic excitation, a diode rectifier unit and a built-in voltage regulator. The generator is driven by a poly-V...

itemprop="image"

Generator — check
To complete the work you will need an assistant, as well as: multimeter (in voltmeter mode with a measurement range of 15-20 V); technical stethoscope. Sequence of execution 1. Prepare the car for...

Generator Drive Belt — Checking Condition
1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Visually check the condition of the generator drive belt. 3. If cracks, signs of wear or other damage are found on...

Generator Drive Belt — Replacement
Note: To perform this work, you will need a special belt installation tool 67.7834-9703. In extreme cases, the belt can be carefully installed without the tool, being careful not to damage it. To...

Voltage Regulator — Replacement
Removal 1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (" Preparing the car for maintenance and repair "). 2. Disconnect the wiring harness...

Generator — removal and installation
Removal 1. Remove the generator drive belt (" Generator Drive Belt - Replacement "). 2. Remove the wire tips from the contact bolt. 3. Disconnect the wires from the generator (see " Voltage Regulator...

Generator — repair
Note: You can check the stator and rotor winding for breakage without removing the generator from the vehicle. To do this, you need to remove the rectifier block. To complete the work you will need:...

Description of the starter design
Starter details: 1 - rear cover mounting nuts; 2 - back cover; 3 - brush assembly mounting screws; 4 - brush springs; 5 - brush unit; 6 - starter (with magnets); 7 - anchor; 8 - thrust washer; 9 -...

Starter — removal and installation
Removal 1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (" Preparing the car for maintenance and repair "). 2. Remove the air filter housing ("...

Starter — repair
Depending on the malfunction that has occurred, the sequence and scope of repair work may be changed. The most common starter faults: 1. The winding burns out or the contact bolts and contact plate...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Power devices Lada Kalina Sedan (2004-2013, VAZ-1118)
• Electrical equipment: Power devices Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Power devices Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Power devices Lada Largus 1 (2012-2023)

Link to this section in various formats

TEXTHTMLBB Code