Vehicle lighting and alarm Lada Granta 1

Lighting, light and sound signaling
The car is equipped with two headlights with halogen high and low beam lamps. To adjust the direction of the low beam, each headlight has two adjusting screws. They allow you to change the direction...

Lighting control unit — removal and installation
Removal 1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (" Preparing the car for maintenance and repair "). 2. Remove the instrument panel trim...

Headlight unit — light adjustment
To complete the work you will need an assistant, as well as: flat horizontal area (preferably near the wall of a house, fence or gate); 5m tape measure; sheet of cardboard (to cover the headlight...

Headlight — replacing bulbs
Warning! Do not touch the halogen lamp bulbs with your fingers. Work in clean cotton gloves without rubber coating. Greasy fingerprints left on the lamp bulb will reduce its service life several...

Headlight — removal and installation
Note: The work is shown on the left headlight. Removal of the right headlight is performed in a similar manner. Removal 1. Prepare the car for work and disconnect the wire terminal from the negative...

Side turn signal — removal, bulb replacement and installation
1. Prepare the car for work (" Preparing the car for maintenance and repair "). Warning: When removing the pointer, do not apply excessive force to avoid breaking the pointer's spring clip, which is...

Tail light — replacing bulbs
1. Prepare the car for work (" Preparing the car for maintenance and repair "). Turn off the outside lighting. 2. In the luggage compartment, open the valve in the luggage compartment trim. 3. Turn...

Tail light — removal and installation
Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). Turn off the outside lighting. 2. Open the valve in the luggage compartment trim. We squeeze the clamps and...

License Plate Lights — Bulb Replacement, Removal and Installation
The car is equipped with two license plate lights. They are located in the niche of the rear bumper. Replacing lamps in headlights is performed in the same sequence. The lights can be removed both...

Interior light — replacement of lamps, removal and installation
Ceiling lamp with individual lighting fixtures Note: To replace a faulty lamp, simply remove the lampshade diffuser. To replace the individual lighting lamp switch and to clean the contacts of the...

Trunk light — removal, replacement of the bulb and installation
1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Using a slotted screwdriver with a thin blade, press the retainer and remove the lamp from the body opening. 3....

Horn — Removal, Adjustment and Replacement
Removal 1. Remove the front bumper grille (" Front bumper - removal and installation "). 2. Disconnect the wiring harness connector from the horn. 3. Using a 13 mm open-end wrench, unscrew the horn...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Lighting and signaling Lada Kalina Hatchback (2004-2013, VAZ-1119)
• Electrical equipment: Lighting and signaling Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Lighting and signaling Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Lighting and signaling Lada Largus 1 (2012-2023)
• Electrical equipment: Lighting and signaling Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code