Lighting, light and sound signaling For the convenience of driving and ensuring traffic safety, external and internal lighting devices are installed on the car. The road in front of the car is illuminated by two block headlights that...
Block headlight — adjustment The direction of the headlights should be such that the road in front of the car is well lit, and the included low beam does not dazzle the drivers of oncoming vehicles. We first check the headlight...
Block headlight — replacing lamps Block headlight: 1 - high beam lamp cover; 2 - lamp holder for daytime running light and side light; 3 - screw for adjusting the low beam in the horizontal plane; 4 - turn signal lamp socket; 5 - low...
Block headlight — removal and installation Removing 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. Remove the front bumper cover (see « Front bumper - removal and installation »). 3. We release the...
Fog lamp — adjustment To perform the work, you will need a horizontal platform next to a flat vertical surface (for example, near the wall of the house) or a sheet of plywood (thick cardboard) size approx. 2x1 m, tape...
Fog lamp — lamp replacement 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. In the niche of the front wheel, turn clockwise... ...and remove the hatch cover. 3. Through the hatch, press...
Fog lamp — removal and installation Removing 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). Comment. It is more convenient to perform work on a viewing ditch or overpass. 2. Disconnect the front...
Rear Light — Bulb Replacement The need to perform this operation is determined during the inspection of the technical condition of outdoor lighting (see « Lighting, light and sound signaling »). Recommendation. When working, make...
Rear lamp — removal and installation Outdoor section 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. In the luggage compartment, open the upholstery valve. Comment. For clarity, the work below...
Rear fog light lamp — removal and installation Removing 1. We prepare the car for work and install it on a viewing ditch or overpass (see « Preparing the car for maintenance and repair »). 2. We release the latch and disconnect the block of the...
Luggage compartment lighting — removal and installation I. Preparing the car for work (see « Preparing the car for maintenance and repair »). 2. With a slotted screwdriver with a thin blade, we press the latch... ... and remove the cover from the hole in...
License plate light — removal and installation 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. With a slotted screwdriver with a thin blade, we press the latch... ... and remove the lamp from the trunk...
Threshold illumination lamp — removal and installation I. Preparing the car for work (see « Preparing the car for maintenance and repair »). 2. With a slotted screwdriver with a thin blade, we press the latch... ... and remove the lantern from the door...
Glove box lighting — removal and installation 1. We prepare the car for work (see « Preparing the car for maintenance and repair »). 2. With a slotted screwdriver with a thin blade, we press the latch and remove the lantern from the lining. 3....
Sound signal — removal, adjustment and installation The horn is installed behind the radiator grill on the right side. Comment. An audible alarm is installed in the engine compartment on the left side. The horn plays an important role in road safety....