Vehicle controls and instruments Lada Vesta 1

General information about the Lada Vesta car
The car was created on the Lada BC platform, which was new for AvtoVAZ, using design developments, as well as components and assemblies from the Nissan-Renault Alliance. Lada Vesta At the same time,...

Overall dimensions of Lada Vesta cars
* At full load to the engine crankcase/to the engine splash guard. Ground clearance 167 mm.

Technical characteristics of cars
Technical characteristics of cars (according to the manufacturer's data) * May vary depending on vehicle configuration. ** Provision is made for installation of HR16 engines with a capacity of 114 hp...

Vehicle and component identification numbers
Vehicle Identification Number The vehicle identification number (VIN) is stamped on the B-pillar of the vehicle on the right side. Identification plate: 1 - company; 2 - vehicle approval number; 3 -...

Keys to the car
The car comes with a set of two keys. Both keys fit the car's door locks and the ignition switch. The kit includes a tag with the key number, which can be used to order a new key from an authorized...

Replacing the battery in the remote control
Note: The remote control uses a CR2032 battery. 1. Using a thin slotted screwdriver, pry from the corner and separate the cover from the key body... ...and open the remote control. Warning! To avoid...

Governing bodies
Location of controls: 1 - internal door opening handle; 2 - air conditioning deflector; 3 - left steering column switch (exterior lighting and turn signal switch); 4 - steering wheel; 5 - instrument...

Instrument panel
Instrument cluster: 1 - Information display (see below " Information displays "); 2 — tachometer. Shows the current engine crankshaft speed (thousands of rpm). The red zone of the scale indicates the...

itemprop="image"

Control lamps
Note: All instruments and control lamps of the instrument panel (except for the door opening and headlight indicator lights) work only when the ignition is on - the key position in the ignition...

Information display
On the instrument panel 1, on the instrument panel 2 and on the central console 3 there are information displays that display information about the operation of various vehicle systems (including...

Ignition switch (lock)
The ignition switch (lock) is installed on the steering column on the right. The key in the ignition switch can be in the following positions: A (STOP) — blocking . The following power consumers are...

Immobilizer (anti-theft device)
The car is equipped with a standard anti-theft system - an immobilizer. When the key is inserted into the ignition switch, a special immobilizer sensor reads the secret code from it. If the chip in...

Steering column switches
The steering column paddle shifters are mounted on the steering column. The left steering column stalk combines the turn signal and headlight switch, as well as the low/high beam switch. The right...

Electric headlight corrector
The electric headlight corrector is designed for remotely changing the angle of the low beam headlights in the vertical plane under different vehicle loads. The car can be equipped with an electric...

Electric windows in the doors
The cars are equipped with electric front windows as standard. The power window control unit is located on the driver's door armrest and can be used to control all power windows. Depending on the...

Air conditioning control unit
The climate control unit is located on the center console. Depending on the configuration, three types of climate control systems can be installed on the car: with manual control without air...

Gear shift lever
On vehicles equipped with a manual transmission, gears are engaged manually according to the diagram printed on the gear shift lever handle. To engage and change gears, you need to press the clutch...

Automatic transmission mode selector
The operating modes of the automated transmission (AT) are controlled using the selector lever installed on the floor tunnel between the front seats. Switching between modes is carried out in...

Parking brake
The parking brake lever is located on the floor tunnel between the front seats and has a cable drive to the rear brake mechanisms. To engage the parking brake, pull the lever up until it stops (5-7...

Adjusting the seat and steering wheel position
The design of the front seats allows them to be moved longitudinally, as well as changing the angle of the backrest. Handle 1 is used to adjust the position of the cushion in the longitudinal...

Adjusting the rear view mirrors
The car is equipped with one internal and two external rear-view mirrors. All mirrors are adjustable in vertical and horizontal planes. The interior rearview mirror has two fixed positions: "day" and...

Use of seat belts
The vehicle is equipped with three-point inertia reel seat belts for the driver and passengers, including the middle passenger in the rear seat. Warning! Always wear a seat belt and make sure all...

Lighting fixtures
To illuminate the interior, two lamps are installed on the ceiling trim: the front one is between the sun visors, and the rear one is between the front and rear seats. In addition, the front ceiling...

Storage boxes
To open the storage compartment located in front of the passenger seat, pull the handle of its lock towards you. A light fixture is installed in the glove compartment. The front door trims have...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Control system Lada Kalina Hatchback (2004-2013, VAZ-1119)
• User manual: Governing bodies Lada Granta 1 (2011-2023, VAZ-2190)

Link to this section in various formats

TEXTHTMLBB Code