Tightening torques for threaded connections Table 11.3.1. Tightening torques for threaded connections Name of parts Torque. Nm Wheel bolt 105 Nut of a nave of a back wheel 175 Bolt of fastening of an arm of a beam of a back suspension bracket...
Description of the design of the rear suspension Rear Suspension Details: 1 - flange of the trailing arm; 2 - shock absorber; 3 - spring; 4 - rear suspension beam; 5 - trailing arm of the beam The rear suspension of the car is semi-independent,...
Checking the technical condition of the rear suspension We check the technical condition of the rear suspension in accordance with the maintenance regulations (see « Maintenance plan »). You can assess the technical condition of the suspension while the...
Rear shock absorbers — replacement Warning! Shock absorbers must be replaced in pairs, even if only one is defective. Do not remove both shock absorbers at the same time with the vehicle suspended, as excessive lowering of the rear...
Rear suspension springs — replacement We replace the springs if the check of the technical condition of the rear suspension (see « Checking the technical condition of the rear suspension ») found that one or both springs were faulty....
Rear suspension beam — removal and installation The need to perform work is determined during the inspection of the technical condition of the rear suspension (see « Checking the technical condition of the rear suspension »). The beam is replaced...