Outdoor section
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. In the luggage compartment, open the upholstery valve.
Comment. For clarity, the work below is shown with the upholstery removed.
3. We release the clamps and disconnect the wiring harness pads from the turn signal lamp...
... lamps of a signal of braking and dimensional light.
4. Using an 8 mm wrench, unscrew the three fastening nuts.
5. We move the lamp back, removing the guides from the body and disconnecting the holder.
6. Remove the lantern.
7. Install the lamp in reverse order.
Inner section
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the upholstery of the tailgate (see «Upholstery of the luggage compartment lid - removal and installation»).
3. We release the clamps and disconnect the wiring harness pads from the reversing light lamp...
...and headlights.
4. Using an 8 mm wrench, unscrew the three fastening nuts...
...and remove the lantern.
5. Install the parts in reverse order.