Figure 11-1 - Rear fog light: 1 - rear fog light; 2 - rear bumper
Removal
Place the vehicle on a two-post lift (electro-hydraulic lift type P-3.2 G with a lifting capacity of 3.2 t).
Turn off the ignition, lift the hood, disconnect the ground wire terminal from the battery (spanner 10).
Raise the vehicle to a height convenient for performing the work.
Unscrew the two screws 1, Figure 11-2, self-tapping fastenings of the rear fog light 2 to the rear bumper 4 and remove the rear fog light from the socket in the rear bumper (t20 replaceable nozzle, ratchet).
Figure 11-2 - Rear fog light mounting: 1 - self-tapping screw; 2 - rear fog light; 3 - Rear bumper wiring harness connector; 4 - rear bumper
Disconnect connector 3 of the rear bumper wiring harness from connector 2 of the rear fog light and remove the light.
Installation
Install the rear fog light 1, Figure 11-1, in the reverse order of removal.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.21.3, 1.19.21.6 in the scope of work performed.