Car maintenance Lada XRAY 1
Maintenance schedule
TO 0 (2500 km mileage): Replace engine oil and oil filter. It is not necessary to change the oil at TO-0. Make sure there are no extraneous noises when the engine is running Make sure there are no...
TO 0 (2500 km mileage): Replace engine oil and oil filter. It is not necessary to change the oil at TO-0. Make sure there are no extraneous noises when the engine is running Make sure there are no...
Checking the oil level in the engine oil pan
We check the oil level in the oil pan on a horizontal surface with the engine not running. If the engine was running before checking, then stop it. We wait at least three minutes (the oil should have...
We check the oil level in the oil pan on a horizontal surface with the engine not running. If the engine was running before checking, then stop it. We wait at least three minutes (the oil should have...
Checking the level and adding coolant
It is advisable to check the fluid level in the expansion tank of the cooling system during each inspection of the car before driving and definitely in the event of engine overheating and the...
It is advisable to check the fluid level in the expansion tank of the cooling system during each inspection of the car before driving and definitely in the event of engine overheating and the...
Checking the gearbox oil level
It is necessary to check the oil level in the gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cooled gearbox. Using a rag, clean...
It is necessary to check the oil level in the gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cooled gearbox. Using a rag, clean...
Gearbox oil change
The gearbox oil must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil on a warmed-up...
The gearbox oil must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil on a warmed-up...
Checking the oil level in the transfer case
It is necessary to check the oil level in the transfer case every 15 thousand km, and also if oil leaks are detected on the transfer case housing. We check the oil level on a cold transfer case....
It is necessary to check the oil level in the transfer case every 15 thousand km, and also if oil leaks are detected on the transfer case housing. We check the oil level on a cold transfer case....
Changing the oil in the transfer case
The oil in the transfer case must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil on a...
The oil in the transfer case must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil on a...
Checking the oil level in the front axle gearbox
It is necessary to check the oil level in the front axle gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cold gearbox. Using a...
It is necessary to check the oil level in the front axle gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cold gearbox. Using a...
Changing the oil in the front axle gearbox
The oil in the front axle gearbox must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil...
The oil in the front axle gearbox must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil...
Checking the oil level in the rear axle gearbox
It is necessary to check the oil level in the rear axle gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cold gearbox. Using a rag,...
It is necessary to check the oil level in the rear axle gearbox every 15 thousand km, and also if oil leaks are detected on the gearbox housing. We check the oil level on a cold gearbox. Using a rag,...
Changing the oil in the rear axle gearbox
The oil in the rear axle gearbox must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil...
The oil in the rear axle gearbox must be changed every 45 thousand km. On a new car, the oil must be changed after 2000 km and then changed after 45 thousand km. It is recommended to change the oil...
Checking the fluid level in the brake hydraulic reservoir
The brake fluid reserve for the hydraulic brake drive is located in a reservoir located on the main brake cylinder. To monitor the brake fluid level, a sensor is installed in the reservoir cap. When...
The brake fluid reserve for the hydraulic brake drive is located in a reservoir located on the main brake cylinder. To monitor the brake fluid level, a sensor is installed in the reservoir cap. When...
Bleeding the hydraulic brake system, replacing the fluid
Lada X-Ray. Bleeding the hydraulic brake system, replacing the fluid We bleed the brakes to remove air from the hydraulic drive after it has become depressurized when replacing the master cylinder,...
Lada X-Ray. Bleeding the hydraulic brake system, replacing the fluid We bleed the brakes to remove air from the hydraulic drive after it has become depressurized when replacing the master cylinder,...
Checking the fluid level in the clutch hydraulic reservoir
The reserve of brake fluid for the clutch hydraulic drive is located in a reservoir located on the left side of the front shield. The brake fluid level in the reservoir with the cap installed should...
The reserve of brake fluid for the clutch hydraulic drive is located in a reservoir located on the left side of the front shield. The brake fluid level in the reservoir with the cap installed should...
Bleeding the clutch hydraulic drive, replacing the fluid
We bleed the clutch hydraulic drive to remove air from it after it has become depressurized when replacing the master cylinder, slave cylinder, hoses, tubes, and also in the case of replacing the...
We bleed the clutch hydraulic drive to remove air from it after it has become depressurized when replacing the master cylinder, slave cylinder, hoses, tubes, and also in the case of replacing the...
Checking the fluid level in the power steering reservoir
The fluid poured into the hydraulic power steering system is designed for the entire service life of the vehicle. We check the fluid level in the power steering reservoir at each maintenance, as well...
The fluid poured into the hydraulic power steering system is designed for the entire service life of the vehicle. We check the fluid level in the power steering reservoir at each maintenance, as well...
Checking the condition of the front wheel brakes
We check the condition of the brake pads and discs in accordance with the maintenance regulations every 15 thousand km. To check, we remove the front wheels one by one. We evaluate the thickness of...
We check the condition of the brake pads and discs in accordance with the maintenance regulations every 15 thousand km. To check, we remove the front wheels one by one. We evaluate the thickness of...
Checking and adjusting the clearance in the front wheel hub bearings
We check the clearance in the front wheel hub bearings in accordance with the maintenance regulations every 15 thousand km. We remove the front wheel. Using a chisel, separate the cap from the hub....
We check the clearance in the front wheel hub bearings in accordance with the maintenance regulations every 15 thousand km. We remove the front wheel. Using a chisel, separate the cap from the hub....
Checking the condition of the rear wheel brakes
We check the condition of the brake pads in accordance with the maintenance regulations every 30 thousand km. We assess the degree of wear of the rear wheel brake pads based on the condition of the...
We check the condition of the brake pads in accordance with the maintenance regulations every 30 thousand km. We assess the degree of wear of the rear wheel brake pads based on the condition of the...
Adjusting the parking brake
The parking brake should hold the vehicle on a 23% slope. The full stroke of the parking brake drive lever should be 7-13 teeth (clicks) of the ratchet device of the lever sector. We hang up the rear...
The parking brake should hold the vehicle on a 23% slope. The full stroke of the parking brake drive lever should be 7-13 teeth (clicks) of the ratchet device of the lever sector. We hang up the rear...
Checking the functionality and adjusting the drive of the rear brake pressure regulator
We check the performance of the pressure regulator in accordance with the maintenance regulations every 30 thousand km. We carry out the work with an assistant, having installed the car on an...
We check the performance of the pressure regulator in accordance with the maintenance regulations every 30 thousand km. We carry out the work with an assistant, having installed the car on an...
Checking the condition and replacing the auxiliary drive belt
In accordance with the maintenance regulations, we check the condition of the auxiliary drive belt every 10 thousand km. To check the condition of the belt... ...by pulling it up... ...we remove the...
In accordance with the maintenance regulations, we check the condition of the auxiliary drive belt every 10 thousand km. To check the condition of the belt... ...by pulling it up... ...we remove the...
Checking the condition and replacing the power steering pump drive belt
In accordance with the maintenance regulations, we check the condition of the power steering pump drive belt every 10 thousand km. We carry out the work by placing the car on a level surface. To...
In accordance with the maintenance regulations, we check the condition of the power steering pump drive belt every 10 thousand km. We carry out the work by placing the car on a level surface. To...
Checking the condition and replacing spark plugs
The manufacturer recommends using domestic spark plugs A17DVRM or imported spark plugs - BRISK "Super" LR17YC, LR15YC. In accordance with the maintenance regulations, we replace the spark plugs every...
The manufacturer recommends using domestic spark plugs A17DVRM or imported spark plugs - BRISK "Super" LR17YC, LR15YC. In accordance with the maintenance regulations, we replace the spark plugs every...
Replacing the fuel filter
In accordance with the maintenance regulations, we replace the fuel filter every 30 thousand km. If the vehicle is operated in very dusty conditions or with low-quality fuel, the filter must be...
In accordance with the maintenance regulations, we replace the fuel filter every 30 thousand km. If the vehicle is operated in very dusty conditions or with low-quality fuel, the filter must be...
Replacing the air filter element
The air filter element must be replaced every 30 thousand km. When operating a vehicle in a dusty area, the mileage between element replacements should be reduced by 1.52 times. A deformed or damaged...
The air filter element must be replaced every 30 thousand km. When operating a vehicle in a dusty area, the mileage between element replacements should be reduced by 1.52 times. A deformed or damaged...
Replacing the replacement element of the outdoor air filter of the heating, ventilation and air conditioning system
We replace the replaceable element of the outside air purification filter in accordance with the maintenance regulations every 15 thousand km. The outside air filter is located under the windshield...
We replace the replaceable element of the outside air purification filter in accordance with the maintenance regulations every 15 thousand km. The outside air filter is located under the windshield...
Checking the condition of suspensions and transmission
We check the condition of the transmission and suspensions in accordance with the maintenance regulations every 10 thousand km. On the chassis parts (wheels, suspension arms, anti-roll bar, front...
We check the condition of the transmission and suspensions in accordance with the maintenance regulations every 10 thousand km. On the chassis parts (wheels, suspension arms, anti-roll bar, front...
Lubrication of cardan shaft crosspiece bearings
We lubricate the crosspiece bearings in accordance with the maintenance regulations every 10 thousand km. We carry out the work on an inspection ditch or overpass. We clean the grease nipples from...
We lubricate the crosspiece bearings in accordance with the maintenance regulations every 10 thousand km. We carry out the work on an inspection ditch or overpass. We clean the grease nipples from...
Checking the condition of the steering
We check the condition of the steering system in accordance with the maintenance regulations every 10 thousand km. We carry out the work on an inspection ditch or overpass. There must be no...
We check the condition of the steering system in accordance with the maintenance regulations every 10 thousand km. We carry out the work on an inspection ditch or overpass. There must be no...
Battery Maintenance
The level and density of the electrolyte in the battery are checked every 10 thousand km in accordance with the maintenance regulations. To maintain the battery in working condition, it is necessary:...
The level and density of the electrolyte in the battery are checked every 10 thousand km in accordance with the maintenance regulations. To maintain the battery in working condition, it is necessary:...
Adjusting the direction of the headlight beams
Select a flat horizontal area within the vehicle base at a distance of 5 m from the screen - a light wall of a building, garage, etc. You can use a sheet of plywood or hardboard measuring 1 x 2 m....
Select a flat horizontal area within the vehicle base at a distance of 5 m from the screen - a light wall of a building, garage, etc. You can use a sheet of plywood or hardboard measuring 1 x 2 m....
Tightening torques for threaded connections of units and assemblies
Tightening torques for threaded connections of units and assemblies Name of the fastener Tightening torque, Nm (kgf.m) Bolt for fastening the bracket of the right suspension support to the engine...
Tightening torques for threaded connections of units and assemblies Name of the fastener Tightening torque, Nm (kgf.m) Bolt for fastening the bracket of the right suspension support to the engine...
List of standard tools and personal protective equipment
List of standard tools and personal protective equipment used for maintenance and repair of Lada vehicles Document number Name GOST R 12.4.013-97 Protective glasses GOST 12.4.028-76 Respirators type...
List of standard tools and personal protective equipment used for maintenance and repair of Lada vehicles Document number Name GOST R 12.4.013-97 Protective glasses GOST 12.4.028-76 Respirators type...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More sections with information from manuals for Lada:
• General information: Maintenance Lada Kalina Hatchback (2004-2013, VAZ-1119)
• User manual: Maintenance Lada Granta 1 (2011-2023, VAZ-2190)
• General information: Maintenance Lada Priora 1 (2007-2018, VAZ-2170)
• General information: Maintenance Lada Vesta 1 (2015-2023, VAZ-2180)
• General information: Maintenance Lada Largus 1 (2012-2023)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Daily care
- Troubleshooting
- Power unit
- Engine repair
- Fuel system
- Cooling system
- Repair H4M engine
- Transmission
- Clutch and drive shafts
- Transmission
- Chassis (running gear)
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Lighting and signaling

itemprop="image"