Gearbox of car Lada XRAY 1

Transmission — general description of the system, features of the device
Work must be carried out in accordance with the requirements of the "Intersectoral rules for labor protection in motor transport" POT RM-027-2003 and labor protection instructions for fitters working...

Gearbox JH3 with engine H4M
Removal Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition (two-post lift type P3.2G with a lifting capacity of 3.2 t). Figure 3-1 - Battery: 1 - battery; 2, 5 -...

Gearbox JR5 with engine 21129
Removal Place the vehicle on a two-post lift, apply the parking brake and turn off the ignition (two-post lift type P3.2G with a lifting capacity of 3.2 t). Open the hood, unscrew nuts 2 and 5,...

Gearbox 21820 with engine 21179
Note: For vehicles equipped with an automated manual transmission (AMT): after replacing any of the AMT components (robotic gearbox control controller, gear shift actuator, clutch release actuator,...

Gear shift control drive (cable)
Removal Place the vehicle on a two-post lift, apply the parking brake, turn off the ignition, open the hood and disconnect the ground wire from the battery (two-post lift type P3.2G with a lifting...

Gear shift control drive (electric)
Removal to be carried out in accordance with the requirements of the section Gear shift mechanism control drive cable of this TI, with the exception of the operation of disconnecting the control...

Robotic gearbox control controller — removal and installation
Removal Place the vehicle on a work stand, apply the parking brake, turn off the ignition, open the hood and disconnect the ground wire terminal from the battery (spanner 10). Remove the front bumper...

Gearshift actuator — removal and installation
Attention: When performing operations of removing/installing the gearshift actuator, it is not allowed: disassembly of the actuator, except in cases where it is impossible to remove the actuator from...

Clutch Release Actuator and Transmission Wiring Harness
Attention: When performing operations of removing/installing the clutch release mechanism actuator, it is not allowed: disassembling the actuator and removing the rubber seal of the rod; actuator...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Transmission: Car gearbox Lada Kalina Sedan (2004-2013, VAZ-1118)
• Transmission: Car gearbox Lada Granta 1 (2011-2023, VAZ-2190)
• Transmission: Car gearbox Lada Priora 1 (2007-2018, VAZ-2170)
• Transmission: Mechanical gearbox Lada Vesta 1 (2015-2023, VAZ-2180)
• Transmission: Car gearbox Lada Largus 1 (2012-2023)

Link to this section in various formats

TEXTHTMLBB Code