Removal
to be carried out in accordance with the requirements of the section Gear shift mechanism control drive cable of this TI, with the exception of the operation of disconnecting the control drive cables from the gearbox.
Figure 4-5 - Removing the gearshift control drive: 1 - electric gear shift control drive; 2 - connector
Additionally, perform the following operation: disconnect the wiring harness connector from connector 2, Figure 4-5, of control drive 1.
Installation
Installation shall be carried out in accordance with the requirements of the section Gear shift mechanism control drive cable of this TI, with the exception of the operation of connecting the control drive cables to the gearbox.
Additionally, perform the following operation: connect the wiring harness connector to connector 2, Figure 4-5, of control drive 1.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.15, 1.19.16, 1.19.21.3.