1. Remove the floor tunnel lining (see "Removal and installation of floor tunnel linings").
2. Using a 13 mm spanner, unscrew the gear shift lever axle mounting nut.
3. Remove the screw securing the lever axle stop.
4. Press the lever to the side and remove the lever axle assembly with the stop.
5. After removing the lever from the traction fork, remove the two plastic axle bushings and the spacer bushing.
6. Replace worn or broken bushings. Please note that the plastic bushings are split, which is not a defect.
7. Install all parts in the reverse order of removal, after lubricating the plastic axle bushings with consistent grease.
8. If difficulties arise when installing the lever axis, in order to be able to move the lever further to the side, remove the protective plate from underneath the car by unscrewing the two nuts that secure it, and unscrew the two bolts that secure the reaction rod. After installing the axle, reinstall the torque rod and adjust the gearshift drive (see "Adjusting the gearbox control drive").