Removal
Place the vehicle in a work area, apply the parking brake, turn off the ignition, lift the hood, and disconnect the ground wire from the battery (spanner 10).
Open the glove compartment lid.
The lampshade 1, figure 15-1, for lighting the glove compartment is held by a retainer and a spring latch in the socket on the body 2 of the glove compartment.
Figure 15-1 - Installing the glove compartment light on the vehicle: 1 - glove compartment light; 2 - glove box body
Insert a flat-head screwdriver into the slot on the front side of the glove compartment light, carefully press the light housing and remove it from the socket on the glove compartment body (flat head screwdriver).
Disconnect connector 1, Figure 15-2, of the instrument panel wiring harness from the connector and remove glove compartment light 2.
Figure 15-2 - Replacing the glove compartment light bulb: 1 - Instrument cluster wiring harness connector; 2 - glove compartment light; 3 - glove box body; 4 - W5W lamp
Replacing the lamp
To replace the glove compartment light bulb, you need to:
- remove the lampshade 2, figure 15-2, of the glove compartment lighting from the socket of the housing 3 of the glove compartment (flat head screwdriver);
- remove lamp 4 from the spring contacts of the glove compartment light (flat head screwdriver).
Install a new lamp in the glove compartment light in the reverse order of removal. The type of lamp to be installed is W5W.
Installation
Install the lampshade 1, Figure 15-1, for the glove compartment lighting in the reverse order of removal. When installing, ensure that the lampshade is securely fixed in the socket of the glove compartment body.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.21.3, 1.19.21.6 in the scope of work performed.