Figure 12-1 - Additional brake signal: 1 - additional brake signal; 2 - retainer; 3 - additional brake light wiring harness connector; 4 - additional brake light wiring harness
Removal
Place the vehicle in a work area, apply the parking brake, turn off the ignition, lift the hood, disconnect the ground wire terminal from the battery, (spanner 10).
Open the trunk and disconnect the rear wiring harness connector from connector 3 of the additional brake light wiring harness.
Disconnect the clamp 2 securing the additional brake light wiring harness block from the vehicle body.
Remove shelf 1, figure 12-2, of the luggage compartment assembly with additional brake signal 2 in accordance with the requirements of TI 3100.25100.20599.
Figure 12-2 - Trunk shelf with additional brake light assembly on the vehicle: 1 - trunk shelf; 2 - additional brake signal
Unscrew two screws 1, Figure 12-3, self-tapping and remove the additional brake signal 2 from the shelf 3 of the trunk (t20 replaceable bit, screwdriver).
Figure 12-3 - Mounting the additional brake light to the luggage compartment shelf: 1 - self-tapping screw; 2 - additional brake signal; 3 - trunk shelf
Installation
Installation of signal 1, Figure 12-1, additional braking is performed in the reverse order of removal.
[Source link - website: LadaMan.ru]
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.21.3, 1.19.21.6 in the scope of work performed.