Removal the additional brake light
Place the vehicle in the work area, apply the parking brake, turn off the ignition, and disconnect the ground wire terminal from the battery (10 mm spanner).
On the vehicle, an additional brake light is installed on the left rear loading door 3, Figure 10-1.
Figure 10-1 Additional brake signal: 1 - additional brake signal; 2 - location of the license plate light; 3 - loading left rear door
Loosen screw 1, Figure 10-2, securing the additional brake light to the left rear loading door 2 (torx 30 bit, screwdriver).
Remove additional brake signal.
Figure 10-2 - Removing the additional brake signal: 1 - brake light mounting screw; 2 - loading left rear door
Disconnect connector 2, Figure 10-3, of the wiring harness from the additional brake light.
Disconnect the additional brake signal from the jet 3, Figure 10-4, of the rear window washer, by pressing the jet holders (flat head screwdriver).
Figure 10-3 - Additional brake signal: 1 - additional brake signal; 2 - wiring harness block to additional brake signal; 3 - additional brake light lamp
Figure 10-4 - Additional brake signal: 1 - additional brake signal; 2 - connector of the rear wiring harness to the additional brake light; 3 - Rear window washer nozzle of the left rear loading door
Turn lamp 3, Figure 10-3, a quarter turn counterclockwise and remove it from the housing of additional brake signal 1.
Removal the trunk light
Disconnect lampshade 2, (see figure 8-2), trunk lighting from the car body (flat head screwdriver).
Disconnect the rear wiring harness connector from the trunk light connector and remove the trunk light.
To replace the lamp, press the contacts and pull the lamp towards you.
Installation
Install the additional brake light bulb by turning it clockwise.
Install the additional brake light and trunk light in the reverse order of removal.