Car engine power system Lada Largus 1

Description of the power supply system design
Engine power supply system 1.6 (16V) Fuel is supplied from a tank installed under the bottom in the area of the second row seat. The fuel tank, filler pipe and ventilation pipe are made of plastic....

Replacing the engine air filter
The air filter should be replaced every 30 thousand km, but if the car is operated in dusty conditions (large city), replacement should be carried out every 15 thousand km. For replacement of the air...

Air filter housing — removal and installation
Engine Air Filter Housing K4M K7M Engine Air Filter Housing (Bottom View) 1 - supply pipe; 2 - filter housing; 3 - nipple of the main crankcase ventilation hose; 4 - fastening the housing to the...

Throttle assembly (pipe) — removal and installation
See part numbers. here and here Throttle assembly 8-valve engine 1 - throttle position sensor; 2 - air filter connection pipe; 3 - body; 4 - throttle valve; 5 - air supply channel to the idle speed...

Replacing the throttle position sensor
The throttle position sensor (TPS) is located on the throttle valve axis (see the location is clear ). See part numbers. here and here Replacement For engine 1.6 (16V) Turn off the ignition. Release...

Intake manifold — removal and installation
Removal Place the vehicle in a work area, apply the parking brake, turn off the ignition and disconnect the ground wire terminal from the battery. For cars with K4M engine Remove the intake noise...

Fuel rail — removal and installation
Fuel rail and fuel injector Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. For station wagons Tilt the rear row of seats forward (for 5-seater...

Adsorber — removal and installation
The adsorber is installed in the arch of the right front wheel. The electromagnetic valve for purging the adsorber is located on its upper cover. Part numbers are listed here . Replacement procedures...

Electric fuel pump module (EFP) — removal and installation
For part numbers of these parts, see here . Disassembly of the fuel module is shown here . Fuel module: 1 – glass; 2 – fuel filter; 3 – module cover; 4 – fuel level indicator sensor; 5 – float When...

Replacing the fuel filter, pump and fuel level sensor
The fine fuel filter (housing), coarse filter (mesh), fuel pump, and fuel level sensor are located in the fuel module complex, which is located in the fuel tank. Note: According to the regulations,...

Fuel tank — removal and installation
Removal Place the vehicle on a two-post lift and apply the parking brake. For vehicles with a "station wagon" body Tilt the rear row of seats forward (for 5-seater configuration) or the middle row...

Fuel and steam pipe — removal and installation
Removal Place the vehicle on a two-post lift and apply the parking brake (electro-hydraulic lift type P-3.2G with a lifting capacity of 3.2 t). For vehicles with a "station wagon" body Tilt the rear...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Supply system Lada Kalina Sedan (2004-2013, VAZ-1118)
• Power unit: Supply system Lada Granta 1 (2011-2023, VAZ-2190)
• Power unit: Supply system Lada Priora 1 (2007-2018, VAZ-2170)
• Power unit: Supply system Lada Vesta 1 (2015-2023, VAZ-2180)
• Power unit: Fuel system Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code