Vehicle lighting and alarm system Lada Largus 1
Adjusting the light of the main and fog lights
To adjust you will need: a 5 mm (or 6 mm) Allen key and a Phillips screwdriver. Note: Check and adjust headlights with the vehicle loaded (with a full tank, tools and a spare tire). 1. Pre-check and,...
To adjust you will need: a 5 mm (or 6 mm) Allen key and a Phillips screwdriver. Note: Check and adjust headlights with the vehicle loaded (with a full tank, tools and a spare tire). 1. Pre-check and,...
Replacing the bulbs in the headlight
The procedure for replacing the right and left headlight bulbs is the same. Location of lamps in the headlight: 1 – direction indicator lamp; 2 – headlight adjustment mechanism; 3 – screw for...
The procedure for replacing the right and left headlight bulbs is the same. Location of lamps in the headlight: 1 – direction indicator lamp; 2 – headlight adjustment mechanism; 3 – screw for...
Headlight — removal and installation
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Remove the front...
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Remove the front...
Headlight corrector and corrector regulator — removal and installation
Note: For part numbers of this part, see here . Removal Disconnect cover 3, Figure 6-2, of the high and low beam lamp socket. Slide the sealing boot 6, Figure 6-3, over the cable sheath. Figure 6-3 -...
Note: For part numbers of this part, see here . Removal Disconnect cover 3, Figure 6-2, of the high and low beam lamp socket. Slide the sealing boot 6, Figure 6-3, over the cable sheath. Figure 6-3 -...
Replacing the fog light bulb
1 – headlight bulb; 2 – adjusting screw See also Adjusting the fog lights . Replacing the lamp It is convenient to carry out the work on an inspection pit or overpass, but you can also get by with a...
1 – headlight bulb; 2 – adjusting screw See also Adjusting the fog lights . Replacing the lamp It is convenient to carry out the work on an inspection pit or overpass, but you can also get by with a...
Replacing fog lights, adjusting light
We remove the fog light for replacement. (catalog numbers are indicated here ). We carry out the work on an inspection ditch or overpass. We show the operations on the left fog light, we remove the...
We remove the fog light for replacement. (catalog numbers are indicated here ). We carry out the work on an inspection ditch or overpass. We show the operations on the left fog light, we remove the...
Side direction indicator — removal, installation and replacement of the lamp
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Press the two...
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Press the two...
Replacing the rear light bulbs
Location of lamps in rear lights: A - left lamp; B - right lamp; 1 – brake light and side light; 2 – direction indicator lamp; 3 – fog light lamp; 4 – Reverse light lamp Lamps used , Lamp article...
Location of lamps in rear lights: A - left lamp; B - right lamp; 1 – brake light and side light; 2 – direction indicator lamp; 3 – fog light lamp; 4 – Reverse light lamp Lamps used , Lamp article...
Rear light — removal and installation
Note: See also Replacing the bulbs in the rear light . For part numbers of the rear light and its parts, see here . Figure 8-1 - Car rear lights: 1 - rear light right/left Removal Place the vehicle...
Note: See also Replacing the bulbs in the rear light . For part numbers of the rear light and its parts, see here . Figure 8-1 - Car rear lights: 1 - rear light right/left Removal Place the vehicle...
Sound signaling device — removal and installation
Note: Catalog numbers of sound signals see here . Depending on the configuration, the Lada Largus can be equipped with one or two sound signals of different tones. The sound signals are located...
Note: Catalog numbers of sound signals see here . Depending on the configuration, the Lada Largus can be equipped with one or two sound signals of different tones. The sound signals are located...
Additional brake light, trunk light
Removal the additional brake light Place the vehicle in the work area, apply the parking brake, turn off the ignition, and disconnect the ground wire terminal from the battery (10 mm spanner). On the...
Removal the additional brake light Place the vehicle in the work area, apply the parking brake, turn off the ignition, and disconnect the ground wire terminal from the battery (10 mm spanner). On the...
License Plate Light — Removal, Installation and Replacement of Bulbs
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). The number plate...
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). The number plate...
Interior and cargo area lighting lamps
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Interior light...
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Interior light...
Glove box light — removal and installation
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Figure 13-1 -...
Removal Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner). Figure 13-1 -...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More sections with information from manuals for Lada:
• Electrical equipment: Lighting and signaling Lada Kalina Hatchback (2004-2013, VAZ-1119)
• Electrical equipment: Lighting and signaling Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Lighting and signaling Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Lighting and signaling Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Lighting and signaling Lada X-Ray 1 (2015-2022)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- Vehicle device
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Supply system
- Ignition system
- Exhaust system
- Spare parts catalog
- Transmission
- Clutch
- Car gearbox
- Drive shafts
- Spare parts catalog
- Chassis (running gear)
- Suspension and wheels
- Steering
- Brake system
- Spare parts catalog
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and ventilation
- Spare parts catalog
- Electrical equipment
- Equipment and devices
- Power devices
- Lighting and signaling
- Spare parts catalog
- Electrical circuits
