Note: Check and adjust headlights with the vehicle loaded (with a full tank, tools and a spare tire).
1. Pre-check and, if necessary, adjust the air pressure in the tires to the correct level. (see here).
2. Place the car opposite the wall, at a distance of 3 m (for example, in the garage). Place an additional 75 kg weight on the driver's seat to simulate the weight of the driver. Mark the screen on the wall as shown in the picture. The longitudinal plane of symmetry of the car must pass along line 0 on the screen. Rock the car laterally to allow the suspension springs to self-align.
3. Measure the distance from the center of the headlights to the floor on your vehicle. This will be the distance h on the screen.
4. Install the headlight range control regulator (if it is installed) on the instrument panel to the position corresponding to the load of the car with one driver. (see here).
5. Turn on the low beam.
6. It is recommended to check the direction of the light spot for each headlight separately. Cover the second headlight with an opaque material during adjustment.
7. If the location of the light spots does not match the picture, open the hood. By turning the adjusting screw (view of the left headlight from the engine compartment), adjust the horizontal position of the light spot on the screen...
8. ...and vertically.
To rotate the vertical adjustment screw, insert an Allen key through the hole in the upper cross member of the radiator frame.
This is how the screw for adjusting the headlights vertically is located.
9. The headlights are considered adjusted when the upper boundaries of the left parts of the light spots coincide with line 4, and vertical lines 1 and 2 pass through points E1 and E2 of intersection of the horizontal and inclined sections of the light spots.
10. If necessary, adjust the second headlight in the same way.
Adjusting fog lights
1. The light beams of the fog lights are adjusted only in height. To access the adjusting screws on the fog light housings, there are holes in the fog light trims. Using a Phillips-head screwdriver, turn the adjusting screws until the top edges of the light spots are on line 4 or slightly below it.
This is how the adjusting screw A is located on the fog lamp housing and the hole B for adjustment in the headlamp trim (view with the fender liner removed).