Note: If the headlight corrector does not work, and one of the headlights begins to shine strongly downwards, then check whether the adjustment cable has slipped off the headlight corrector. To do this, remove the rubber dust cover from the corrector on the headlight and insert the cable into place (see figure here)
Handle 1 is designed to adjust the headlights in the vertical plane. This may be necessary in different cases, depending on the vehicle load.
Turn knob 1 downwards to lower the beam of light, or upwards to raise the beam of light.
Vehicle loading conditions Meaning of handle position A Basic position: vehicle with empty trunk, one driver or driver and one passenger in the front seat. 0 1, 2, 3 passengers and trunk not loaded. 1 3 passengers and the trunk is loaded. 2 One driver and the trunk is fully loaded. 3
The regulator is located on the left side of the panel. Adjust the height of the low beam. There are three numbers on the regulator: "0, 1, 2, (3)". Turn the control knob from 0 to 2 (or 3) one by one and the low beam will gradually lower. Try to turn the handle every one minute. If the regulator is returned too quickly, the electric regulator may malfunction.
(Article copied from the resource: «LADAman»)
