1 – headlight bulb; 2 – adjusting screw
See also Adjusting the fog lights.
Replacing the lamp
It is convenient to carry out the work on an inspection pit or overpass, but you can also get by with a jack.
We remove the wheel and the mudguard from the side of the lamp being replaced.
Unscrew the two screws from below that secure the mudguard to the bumper (torx T-20 key).
and the same screw in the arch
and one screw for attaching the mudguard to the front wing
The remaining screws do not need to be unscrewed. We bend back the mudguard and place its edge behind the brake caliper.
Access to the fog light is open.
After pressing the plastic lock of the wiring block, we remove the connector.
(The wire connector retainer can be pressed with a screwdriver)
Turning the lamp counterclockwise.
We remove the lamp from the fog light housing.
We install the new H11 lamp in the reverse order.