Removal
Place the vehicle in the work area, apply the parking brake, and turn off the ignition. Raise the hood, disconnect the ground wire terminal from the battery (10 mm spanner).
Remove the front bumper.
Unscrew three bolts 1, 3 and 4, Figure 6-1, securing the headlight to the car body (replacement head 10, extension, ratchet).
Figure 6-1 - Removing the headlight: 1, 3, 4 - headlight mounting bolt; 2 - headlight
Figure 6-2 - Headlight: 1 - headlight; 2 - screw for adjusting the optical element in the horizontal plane; 3 - cover of the high and low beam lamp socket; 4 - headlight corrector sealing cover; 5 - socket for side light and daytime running light; 6 - front harness ground terminal; 7 - direction indicator lamp socket
Remove cover 3, Figure 6-2, of the high and low beam lamp socket. Disconnect the lamp connectors.
Slide the sealing cover 4 of the headlight corrector along the cable sheath.
Remove the headlight beam corrector actuator from the headlight housing (see next section).
Remove the parking light bulb socket.
Remove the headlight.
Installation
Install the headlight in the reverse order of removal.
At the same time, ensure uniformity of the gaps between the headlight and the mating parts of the car body.
If necessary headlight bulb replacement remove the protective cap from the engine compartment side of the corresponding lamp, Figure 6-2, and replace the lamp.
Caution: Do not touch the halogen lamp bulb with your fingers. Any remaining grease stains may cause the lamp to overheat and explode. If the lamp glass comes into contact with the lamp, wipe it with a lint-free cloth. Replace lamps wearing clean cloth gloves.
Install the front bumper.
Adjust the direction of the headlights.