Car engine power system Lada Granta 1

Reference data on the engine power supply system
Table 8.3.1. Basic data for monitoring, adjustment and maintenance Fuel (according to GOST R 51105-97) Gasoline "Premium-95" or "Premium Euro-95" Fuel tank capacity, l 50 Fuel module 1118-1139008-20...

Description of the engine power supply system
Location of engine fuel system components in the engine compartment: 1 - intake manifold receiver; 2 - throttle assembly with electric throttle drive; 3 - air supply hose to the throttle valve; 4 -...

Engine power supply system diagram
Engine power supply system diagram: 1 throttle assembly; 2 purge valve of the adsorber; 3 - fuel filter; 4 - fuel tank; 5 - filler pipe; 6 - adsorber; 7 - injectors; 8 - fuel rail diagnostic...

Checking the technical condition of the power supply system
To perform the work you will need a special fuel pressure gauge. Sequence of execution 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Unscrew the protective cap of...

Air filter — replacing the filter element
According to the manufacturer's recommendation, we replace the air filter element after every 30,000 km. Sequence of execution 1. Prepare the car for repairs (" Preparing the car for maintenance and...

Air filter — removal and installation
The operation may be required when repairing the engine and its systems. Therefore, in many cases it makes sense to remove the filter together with the mass air flow sensor or even the air supply...

Intake manifold receiver — removal, replacement of seals and installation
Removal 1. Remove the throttle assembly from the receiver flange studs without disconnecting the cooling system hoses from it (" Throttle assembly - removal, inspection, cleaning and installation ")....

itemprop="image"

Fuel Line — Pressure Relief
1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Remove the fuel pump circuit fuse (" Mounting Block - Replacing Fuses and Relays "). Note: You can disconnect the...

Fuel filter — replacement
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Relieve the fuel pressure (see " Fuel...

Fuel rail — removal, disassembly, assembly and installation
The fuel rail is dismantled when it is necessary to remove the injectors, as well as in other cases during engine repair. Removal 1. Relieve the fuel pressure in the fuel line (" Fuel Line - Pressure...

Fuel module — removal and installation
Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Relieve the fuel pressure (" Fuel Line - Pressure Relief "). Warning! After releasing the pressure, a small...

Fuel Level Gauge Sensor — Replacement
Advice: Malfunctions of the fuel level indicator sensor are most often associated with wear of the contact part of its rheostat. This can be verified by measuring its electrical resistance with an...

Fuel Pressure Regulator — Replacement
Advice: If you suspect that the pressure regulator is faulty, it must be replaced. Removal 1. Remove the fuel module (" Fuel module - removal and installation "). 2. Disconnect the wire tip from the...

Fuel module mesh filter — cleaning
Note: One of the reasons for low fuel pressure in the fuel rail may be a dirty mesh filter of the fuel module. Removal 1. Remove the fuel module (" Fuel module - removal and installation "). 2....

Fuel pump — replacement
Advice: Pump replacement operation requires experience and precision (fuel module components may be damaged), therefore, in case of a fuel pump failure, it is recommended to replace the fuel module...

Fuel tank — removal and installation
The fuel tank has a fuel vapor recovery system adsorber installed on top, and a fuel filter is attached to the right side of the tank. To complete the work, you will need an inspection pit or...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Supply system Lada Kalina Sedan (2004-2013, VAZ-1118)
• Power unit: Supply system Lada Priora 1 (2007-2018, VAZ-2170)
• Power unit: Supply system Lada Vesta 1 (2015-2023, VAZ-2180)
• Power unit: Supply system Lada Largus 1 (2012-2023)
• Power unit: Fuel system Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code