Car front suspension Lada Granta 1

Front Suspension Reference Data
Table 10.2.1. Front wheel alignment angles under 320 kg load Front wheel alignment, hail -0°30'...+0°30' Front wheel alignment, mm -1...+1 Longitudinal tilt of the wheel turning axis, deg 1-2° Table...

Description of the front suspension design
Front suspension: 1 - stabilizer bar; 2 - stabilizer bar mounting bracket; 3 - transverse arm bracket; 4 - transverse lever; 5 - stabilizer strut; 6 - telescopic stand; 7 - ball joint; 8 - steering...

Checking the technical condition of the front suspension
The technical condition of the front suspension must be checked in accordance with the periodic maintenance regulations (" Periodic maintenance "). The technical condition of the suspension can be...

Stretch mount bracket — removal and installation
To carry out the work, you will need an inspection pit or overpass. Sequence of execution 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Holding the tensioner with...

Longitudinal suspension strut — removal and installation
Advice: When adjusting the longitudinal tilt angle of the steering axis at a service center, the longitudinal brace will be removed again, so it is better to replace the brace there, at the same time...

Ball joint of the rack — removal and installation
To complete the work you will need: ball joint pin extractor; car stand. Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Remove the front wheel of the car...

Transverse suspension arm — removal and installation
To complete the work you will need: inspection ditch or overpass; beard. Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Remove the front wheel (" Wheel -...

Wishbone suspension — replacement of rubber-metal hinges
We replace rubber-metal hinges when the hinge in the lever rotates, when it loses elasticity, when the rubber element of the hinge is chipped or squeezed out of its seat. To complete the job you will...

Front suspension strut — removal and installation
To perform the work you will need a reliable support for the car. Removal Warning: Struts should be replaced in pairs, even if only one is faulty. 1. Prepare the car for work (" Preparing the car for...

Front suspension strut — disassembly and assembly
To complete the job, you will need suspension spring clamps and a suspension strut disassembly tool. Disassembly 1. Remove the rack from the car (" Front suspension strut - removal and installation...

Anti-roll bar — replacement of struts
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Using two 17 mm wrenches, unscrew the...

Anti-roll bar — removal, replacement of cushions and installation
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (" Preparing the car for maintenance and repair "). 2. Unscrew the nut of the bolt securing the...

Front Wheel Alignment Check
To ensure correct rolling of the vehicle wheels, taking into account the operation of the suspension and steering, the front suspension elements must be installed in a certain position. It is...