Car front suspension Lada Kalina 1

Front suspension: reference data
Table 10.2.1. Front wheel alignment angles under 320 kg load Table 10.2.2. Front wheel alignment angles for a loaded vehicle Table 10.2.3. Tightening torques for threaded connections

Front suspension: design description
The front suspension is independent, with telescopic swivel struts, transverse levers, longitudinal arm braces and a torsion-type anti-roll bar. The suspension strut consists of a housing in which a...

Checking the technical condition of the front suspension
The technical condition of the front suspension must be checked in accordance with the periodic maintenance schedule (see " Periodic maintenance "). You can assess the technical condition of the...

Stretch mount bracket — removal and installation
To carry out the work, you will need an inspection pit or overpass. Sequence of execution 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Holding the tensioner...

Longitudinal suspension strut — removal and installation
Advice: When adjusting the longitudinal tilt angle of the steering axis at a service center, the longitudinal brace will be removed again, so it is better to replace the brace there, at the same time...

Ball joint of the rack — removal and installation
To complete the work you will need: ball joint pin extractor; car stand. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the front wheel of the...

Transverse suspension arm — removal and installation
To complete the work you will need: inspection ditch or overpass; beard. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the front wheel (see "...

Wishbone suspension — replacement of rubber-metal hinges
We replace rubber-metal hinges when the hinge in the lever rotates, when it loses elasticity, when the rubber element of the hinge is chipped or squeezed out of its seat. To complete the job you will...

Front suspension strut — removal and installation
To perform the work you will need a reliable support for the car. Removal Warning: Struts should be replaced in pairs, even if only one is faulty. 1. Prepare the car for work (see " Preparing the car...

Front suspension strut — disassembly and assembly
To complete the work you will need: suspension spring clamps; device for disassembling the suspension strut. Disassembly 1. Remove the rack from the car (see " Front suspension strut - removal and...

Anti-roll bar — replacement of struts
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Using two 17 mm wrenches, unscrew...

Anti-roll bar — removal, replacement of cushions and installation
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Unscrew the nut of the bolt securing...

Front Wheel Alignment Check
To ensure correct rolling of the vehicle wheels, taking into account the operation of the suspension and steering, the front suspension elements must be installed in a certain position. It is...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Chassis (running gear): Front suspension Lada Granta 1 (2011-2023, VAZ-2190)
• Chassis (running gear): Front suspension Lada Vesta 1 (2015-2023, VAZ-2180)
• Chassis (running gear): Front suspension Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code