Design features of the front suspension By car, the front suspension is independent, telescopic, with hydraulic shock absorber struts, coiled conical springs, lower wishbones with extensions and an anti-roll bar. The main element of the...
Front suspension malfunctions, their causes and solutions Cause of malfunction Remedy Noise (knock) in the suspension when the car is moving Faulty suspension struts The bolts securing the anti-roll bar to the body have loosened. Wear of rubber pads stretch...
Checking the technical condition of the front suspension parts At each maintenance and repair of the car, it is imperative to check the condition of the protective covers of the front suspension ball joints, paying special attention to the absence of mechanical...
Removal and installation of a telescopic rack To remove and install the telescopic rack on a car, you will need: keys «at 13», «at 17», «at 19», key and head «at 19». 1. Brake the vehicle with the parking brake and set the wheel chocks («shoes»)...
Dismantling and repair of a telescopic rack To disassemble and repair the telescopic rack on a car, you will need: ties for suspension springs, a wrench «at 17». 1. Remove the telescopic pole from the vehicle (see « Removal and installation of...
Ball joint replacement 1. Raise and place the front of the vehicle on stands. Remove the wheel from the car. 2. Turn away a nut of fastening of the spherical hinge. 3. Press the ball joint pin out of the lever using a...
Replacing the front suspension arm To replace the front suspension arm on a car, you will need: keys «at 17», «at 19», «at 24». 1. Raise and place the front of the vehicle on stands. Remove the wheel from the car. 2. Apply WD-40 to...
Replacing the brace and brace mounting brace To replace the brace and brace for mounting the brace on a car, you will need: keys «at 24» (two), socket wrench «at 17», wrench for wheel bolts. 1. Loosen the front wheel mounting bolts on the...
Replacement parts of the stabilizer bar 1. Install the car on a viewing hole or lift and support the front of the car on supports. 2. Turn away on one nut of fastening of racks of the stabilizer from both parties of the car. 3. Turn away...
Replacing the front hub bearing To replace the front hub bearing on a car, you will need: a thin chisel, a socket wrench (head) «at 30», circlip pliers, mandrels, large screwdriver, hammer. The front hub has a double-row ball...