Vehicle heating and ventilation system Lada Kalina 1

Design of the electric fan of the cooling system
In a vehicle, the cooling system fan is driven by a permanent magnet DC motor. The fan operation is controlled by the engine management system controller, which receives a signal from the coolant...

Removal and installation the electric motor of the cooling system fan
To remove and install the electric motor of the cooling system fan on a car, you will need: a 10 mm wrench and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the...

itemprop="image"

Design of the electric motor of the fan of the heating and ventilation system of the passenger compartment
The vehicle is equipped with a heater fan electric motor with excitation from permanent magnets. To obtain different rotation speed values, an additional resistor is installed in the power supply...

itemprop="image"

Possible malfunctions of the heater fan motor
Possible malfunctions of the heater fan electric motor, their causes and methods of elimination Cause of malfunction Method of elimination The heater fan motor does not work Damaged wires or oxidized...

Removal and installation the electric motor of the fan of the heating and ventilation system
To remove and install the electric motor of the fan of the heating and ventilation system of the passenger compartment in a car, you will need: flat-head and Phillips-head screwdrivers. 1. Disconnect...

Replacing the additional resistor of the interior heater
To replace the additional resistor of the interior heater in a car, you will need: a flat-blade screwdriver, a Phillips-head wrench. 1. Disconnect the wire from the negative terminal of the battery....

Replacing the heater electric fan mode switch
To replace the heater fan mode switch and rear window defroster switch on your vehicle, you will need a straight-blade screwdriver. 1. Remove the instrument panel trim (see " Disassembly and assembly...

Rear window heating system
The rear window heating element is switched on using relay K10, installed in mounting block . To prevent the battery from being discharged by the heating element left on when the engine is not...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Body and interior: Heating and ventilation Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Cooling and heating Lada Priora 1 (2007-2018, VAZ-2170)
• Body and interior: Heating and ventilation Lada Vesta 1 (2015-2023, VAZ-2180)
• Body and interior: Heating and ventilation Lada Largus 1 (2012-2023)

Link to this section in various formats

TEXTHTMLBB Code