Vehicle starting and charging system Lada Kalina 1

Battery — Removal and Installation
Removal 1. Prepare the vehicle for work and disconnect the wire terminal from the negative terminal of the battery (see " Preparing the car for maintenance and repair "). Similarly, we disconnect the...

Battery — Maintenance
Note: There are sealed maintenance-free batteries available for sale. These batteries do not have holes for adding water or checking the density of the electrolyte. To complete the work you will...

itemprop="image"

Generator — General Information
The vehicle is equipped with a three-phase alternating current generator with electromagnetic excitation, a diode rectifier unit and a built-in voltage regulator. The generator is driven by a poly-V...

itemprop="image"

Generator — check
To complete the work you will need an assistant, as well as: multimeter (in voltmeter mode with a measurement range of 15-20 V); technical stethoscope. Sequence of execution 1. Prepare the car for...

Generator Drive Belt — Checking Condition and Adjusting Tension
To perform the work, you can remove the right front wheel or place the car on an inspection ditch or overpass. Sequence of execution 1. Prepare the car for work (see " Preparing the car for...

Generator Drive Belt — Replacing the Belt and Tensioner Roller
Sequence of execution 1. Loosen the tension of the generator drive belt (see above, " Generator Drive Belt - Checking Condition and Adjusting Tension "). 2. Remove the belt from the generator pulley...

Generator Voltage Regulator — Replacement
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery (see " Preparing the...

Generator — removal and installation
To carry out the work, you will need an inspection pit or overpass. Removal Before removing the alternator drive belt, mark the direction of its rotation with an arrow. 1. Remove the generator drive...

Generator — repair
You can check the stator and rotor winding for breakage without removing the generator from the car. To do this, you need to remove the rectifier block. To complete the work you will need: three- or...

Mounting Block — Replacing Fuses and Relays
Note: The engine management system fuses and relays are located in the center console of the instrument panel (for details, see. " Engine Management System Fuses and Relays - Replacement "). Fuse and...

Starter — General Information
The vehicle is equipped with a starter type 5702.3708*, which is a four-pole electric motor with excitation from permanent magnets, equipped with a starter drive and a traction relay. The armature...

Starter — removal and installation
Removal 1. We prepare the vehicle for work and disconnect the wire terminal from the negative terminal of the battery. " Preparing the car for maintenance and repair "). 2. Remove the air filter...

Starter — repair
Note: Depending on the malfunction that has occurred, the sequence and scope of repair work may be changed. The most common starter faults: 1. The winding burns out or the contact bolts and contact...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Electrical equipment: Power devices Lada Granta 1 (2011-2023, VAZ-2190)
• Electrical equipment: Power devices Lada Priora 1 (2007-2018, VAZ-2170)
• Electrical equipment: Power devices Lada Vesta 1 (2015-2023, VAZ-2180)
• Electrical equipment: Power devices Lada Largus 1 (2012-2023)

Link to this section in various formats

TEXTHTMLBB Code