Design of lighting, light and sound signaling Headlights. On cars, block headlights are used that combine low beam and high beam headlights (with single filament lamps) and direction indicators. In addition, in the headlights there are side...
Lighting malfunctions, light and sound alarms Lighting malfunctions, light and sound alarms, their causes and remedies Cause of malfunction Remedy Individual headlights and taillights do not light up Fuses blown Burnt out lamp filaments Damaged...
Headlight adjustment Check and adjust the headlights on an equipped vehicle: with a fully filled fuel tank, a set of tools and a spare wheel. To adjust the headlights on a car, you need a hex «by 5». 1. Pre-check the air...
Headlight Replacement To replace the headlight unit on a car, you will need a socket wrench «on 10». 1. Disconnect the wire from the terminal «minus» battery. 2. Remove the front bumper (see « Removal and installation of...
Side turn signal replacement 1. Disconnect the wire from the terminal «minus» battery. 2. Remove fender liner (see « Removal and installation of a fender liner »). 3. Move the turn signal forward... 4.... and remove the turn...
Rear fender light replacement You will need a socket wrench to replace the tail light on your car «for 8». 1. Disconnect the wire from the terminal «minus» battery. 2. Bend back the trunk upholstery behind the rear light. 3....
Removal and installation of the interior lighting unit The interior lighting unit is removed to replace the dome light switches and to gain access to the antenna mount. To remove and install the interior lighting unit on a car, you will need: Flat and...
Replacing the outdoor lighting control unit and instruments You will need a flat blade screwdriver to replace the exterior and instrument lighting control unit on your vehicle. 1. Disconnect the wire from the terminal «minus» battery. 2. Pry off the cover of...
Checking and replacing steering column switches The steering column switch consists of a connector fixed with a clamp on the steering gear shaft bracket, and two switches. The left stalk switches on the direction indicators and switches the...