Car engine cooling system Lada Kalina 1

Cooling system reference data
Table 8.2.1. Basic data for monitoring, adjustment and maintenance Table 8.2.2. Tightening torques for threaded connections

Description of the design of the cooling system
The engine cooling system is liquid, closed type with forced circulation of coolant and an expansion tank. The engine cooling system uses special fluids based on a mixture of water and ethylene...

Checking the technical condition of the cooling system
When operating a vehicle, the condition of the cooling system can be assessed using the coolant temperature gauge and the coolant level in the expansion tank. A decrease in the coolant level is...

Coolant — Replacement
We replace the coolant after 75,000 km of mileage, or after five years, whichever comes first. To complete the work you will need a wide container with a capacity of at least 8 liters. It is more...

Expansion tank — removal and installation
Removal 1. Partially drain the coolant (see " Coolant - Replacement "). 2. Disconnect the terminal from the negative and then from the positive terminal of the battery (see " Battery - Removal and...

Thermostat — Removal, Replacement and Installation
The thermostat is detachable - the parts of the thermostat housing are connected with bolts, so if necessary, only the thermostat actuator can be replaced (thermoelement assembled with valves)....

Coolant Pump — Replacement
Removal 1. Drain the coolant (see " Coolant - Replacement "). 2. Remove the rear timing belt cover (see " Camshafts - Removal and Installation "). 3. Using a 5 mm Allen key, unscrew the three bolts...

Additional electric fan resistor — checking and replacing
To complete the work you will need a multimeter. It is more convenient to carry out the work on an inspection ditch or overpass. Removal and inspection 1. Prepare the car for work (see " Preparing...

Electric fan — removal, disassembly and installation
To carry out the work, you will need an inspection pit or overpass. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the air filter and its air...

Engine cooling system radiator — removal and installation
To carry out the work, you will need an inspection pit or overpass. Removal 1. Drain the coolant (see " Coolant - Replacement "). 2. Remove the electric fan (see " Electric fan - removal, disassembly...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections with information from manuals for Lada:

• Power unit: Cooling system Lada Granta 1 (2011-2023, VAZ-2190)
• Power unit: Cooling and lubrication system Lada Priora 1 (2007-2018, VAZ-2170)
• Power unit: Cooling system Lada Vesta 1 (2015-2023, VAZ-2180)
• Power unit: Cooling and lubrication system Lada Largus 1 (2012-2023)
• Power unit: Cooling system Lada X-Ray 1 (2015-2022)

Link to this section in various formats

TEXTHTMLBB Code