Note: The work is shown on the left headlight. Removal of the right headlight is performed in a similar manner.
Removal
1. Prepare the car for work and disconnect the wire terminal from the negative terminal of the battery ("Preparing the car for maintenance and repair").
2. Remove the front bumper ("Front bumper - removal and installation").
3. Disconnect the wiring harness connector from the high/low beam lamp ("Headlight - replacing bulbs").
4. Having released the retainer, we disconnect the wiring harness block from the turn signal.
5. Press the lock and disconnect the headlight hydraulic corrector drive from the headlight unit.
6. Disconnect the wiring harness from the parking light and daytime running lights.
7. Near the radiator, using an 8 mm socket wrench, unscrew one bolt 1 securing the headlight unit...
...and, holding the headlight, with the same key we unscrew two more bolts 2 near the front wing.
8. Remove the headlight.
Installation
We install the headlight in the reverse order. After installation, we adjust the headlights ("Headlight unit - light adjustment").