Removal
1. Prepare the car for work ("Preparing the car for maintenance and repair").
2. Remove the license plate. Using a 10 mm socket wrench, unscrew the two bolts of the upper bumper mount...
... and two lower mounting bolts.
3. Using a TORX T20 key, unscrew the two screws securing the mudguard to the bumper from below...
...and two on the side.
4. We unscrew the screws in the same way on the other side of the car.
5. On cars with fog lights, disconnect the wire connectors from them.
6. Using a 10 mm socket wrench, unscrew the six bolts of the upper radiator trim mount (the photo shows the left side of the grille).
7. Remove the trim from the hood stops.
8. On both sides of the car, we disengage the edges of the bumper from the front fenders and remove the bumper.
9. Using an 8 mm socket wrench, unscrew the nine nuts 1 securing the radiator grille to the bumper and remove the grille. To remove the decorative grille cover, unscrew three nuts 2.
Installation
We assemble and install the bumper in the reverse order.