You will need: socket wrench (head) «on 10», Phillips screwdriver.
1. Disconnect the wire from the terminal «minus» battery.
2. Remove the engine mudguard (see «Removal and installation of a mudguard of the engine»).
3. Turn out from below on three screws of fastening of a bumper to the left and right protective casings of wings.
4. Turn out four screws of fastening of a bumper to the top cross-beam of a bulkhead of a body and two screws of fastening of the right and left casings of headlights to a bumper.
5. Turn out on the left and on the right from the side of the wheel arches, two screws securing the bumper to the front fenders and one screw each to the left and right protective covers of the wings.
6. Remove the bumper by sliding it forward.
7. Turn out three bolts of fastening of a beam of a bumper to the lower cross member of a body …
8.... and remove the beam.
9. Install the removed parts in the reverse order of removal. When installing the bumper, slide its side edges over the edges of the wing covers.