1. Disconnect the wire from the negative terminal of the battery.
2. Remove the mudguard liner and wing protective cover (see "Removing and installing the mudguard and protective wing cover").
3. Remove the decorative threshold trim (see "Removal and installation of decorative door sill trims").
4. Remove the front bumper (see "Removing and installing the front bumper").
5. Move the side turn signal repeater of the front part of the car to the side and remove it from the hole in the wing.
6. Press the lock of the wiring harness connector and disconnect the connector from the repeater.
7. Using an 8 mm spanner, unscrew the front wing mounting bolt.
8. Using an 8 mm spanner, unscrew the lower wing mounting bolt.
9. Using an 8 mm spanner, unscrew the two rear wing mounting bolts through the wheel well.
10. Using an 8 mm spanner, unscrew the three bolts securing the wing to the body and the bolt securing the upper headlight unit, then remove the wing.
11. Install the wing in the reverse order of removal. Recommended (especially when installing a new wing) clean the surfaces on the body that are mated with the wing and install new insulating gaskets between the body and the upper flange of the wing, as well as between the front pillar and the rear flange of the wing. If there are no gaskets, you can cover the mating surfaces with mastic.
12. Before final tightening of the mounting bolts, adjust the wing (due to enlarged holes), ensuring equal and uniform gaps between the wing and the mating body panels. After installing the new fender, apply an anti-corrosion coating to its inner surface.