Removal
Place the vehicle on a two-post lift and apply the parking brake (electrohydraulic lift type P-3.2 G).
Open the hood and disconnect the ground wire terminal from the battery.
Raise the vehicle to a height convenient for performing the work.
Remove piston 3, figure 1-1, securing the shield to the mudguard liner (flat head screwdriver).
Remove piston 4 securing the shield to the subframe (device 7711238605).
Unscrew the three self-tapping screws 1 of the lower bumper mount (torx T20 replaceable head, ratchet).
Remove the lower mudguard 2.
Figure 1-1 - Front bumper mudguard: 1 - self-tapping screw for lower bumper mount; 2 - lower mudguard; 3 - piston for fastening the shield to the mudguard; 4 - piston for fastening the shield to the subframe
Installation
Install the mudguard in the reverse order of removal.