Removal
Place the vehicle on a two-post lift and apply the parking brake (electrohydraulic lift type P-3.2 G).
Open the hood and disconnect the ground wire terminal from the battery.
Raise the vehicle to a height convenient for performing the work.
Unscrew two self-tapping screws 2 on the right and left sides of the car, Figure 3-1, securing the casing to the bumper.
Move the wheel arch protective cover to the side and unscrew the 1 side bumper mounting bolts on the right and left sides of the vehicle (torx T30 replaceable head, extension, ratchet).
(Data taken from the specified website: «ladaman»)
Figure 3-1 - Side bumper mount: 1 - side bumper mounting bolt; 2 - self-tapping screw for fastening the casing to the bumper; 3 - rear wheel arch protective cover
Remove five screws 1, Figure 3-2, of the lower bumper mount (torx T30 replaceable head, ratchet).
Figure 3-2- Lower bumper mount: 1 - lower bumper mounting screw
Figure 3-3 - Rear Bumper Bracket: 1- rear bumper side bracket
Disengage the bumper sides from the side brackets 1, Figure 3-3.
Unscrew the eight bolts 1 securing the bumper, Figure 3-4 (torx T30 replaceable head, ratchet).
Remove the rear bumper.
Figure 3-4 - Upper bumper mount: 1 - Upper bumper mounting bolt
Installation
Installation should be carried out in the reverse order of removal.