Removal
1. Prepare the car for work ("Preparing the car for maintenance and repair").
2. Using a slotted screwdriver with a thin blade, pry up and remove the holder retainer.
3. Using a puller, remove the mudguard holder.
4. Using a TORX T20 key, unscrew the two screws of the upper mudguard mount.
5. Using a Phillips screwdriver, unscrew the screw of the lower mudguard mount...
...and remove the mudguard.
6. Using a Phillips screwdriver, unscrew the bumper mounting screw.
7. Similarly, remove the mudguard and unscrew the screw on the other side of the car.
8. Remove the rear lights ("Tail light - removal and installation").
9. Using a 10 mm socket wrench, unscrew the three screws of the lower bumper mount (one is not visible in the photo).
10. Using the same key, unscrew the four screws securing the bumper. Similarly, unscrew the screws on the other side of the bumper.
11. On both sides of the car, we remove the edges of the bumper from engagement with the rear wing and move the bumper away from the body.
12. Remove the sealing plug of the license plate light wiring harness from the body opening.
13. Pull out the wiring harness and disconnect the pads.
If necessary, remove the license plate lights from the bumper ("License Plate Lights - Bulb Replacement, Removal and Installation").
Installation
We install the rear bumper in the reverse order.