Comment. On the body of the sound signal there is an adjusting screw, by turning which you can adjust the sound of the sound signal. Adjustment is more convenient to carry out with the assistant.
Removing
1. Remove the front bumper grille (see «Front bumper - removal and installation»).
2. Using a 13 mm spanner, unscrew the nut securing the sound signal plate.
3. We remove the sound signal from under the bumper and disconnect the block of the wiring harness from the sound signal.
Recommendation. An adjusting screw is made on the inside of the sound signal. You can apply battery voltage to the horn terminals and adjust the sound of the horn with a slotted screwdriver with a thin blade. If the sound is hoarse and weak, and it is not possible to achieve an acceptable sound by turning the adjusting screw, the sound signal must be replaced.
Installation
Install the sound signal in reverse order.
After installation, we check the operation of the sound signal.