Removal
Place the vehicle on a work stand, apply the parking brake, turn off the ignition and disconnect the ground wire terminal from the battery (spanner 10).
Loosen the two screws securing the steering column covers and, overcoming the force of the clamps, remove the upper and lower steering column covers (torx T20 screwdriver).
Remove the transponder receiving coil from the ignition switch housing in accordance with the requirements of paragraph 5 of this TI.
Loosen bolt 2, Figure 7-1, securing the steering column adjustment mechanism handle and remove handle 1 (torx T20 screwdriver).
Unscrew nut 3 securing axle 4 of the adjustment mechanism, remove washers, needle bearing and axle assembly with locking mechanism (replacement head 10, ratchet wrench).
Figure 7-1 - Removing the steering column adjustment mechanism: 1 - steering column adjustment mechanism handle; 2 - handle mounting bolt; 3 - axle mounting nut; 4 - steering column adjustment mechanism axis
(Article copied from the resource www.LadaMan.ru)
Installation
Caution: When installing the steering column adjustment mechanism, make sure that the two toothed segments 1, Figure 7-2, are installed correctly.
Figure 7-2 - Steering column adjustment mechanism: 1 - toothed segments; 2 - steering column adjustment mechanism axis; 3 - axle mounting nut
Install axle 2, Figure 7-2, of the adjustment mechanism assembled with the locking mechanism on the steering column, install the needle bearing, washers and secure the axle with nut 3 (replacement head 10, ratchet wrench).
Install the adjustment mechanism handle in place and secure it with the bolt (torx T20 screwdriver).
Adjust the stroke force of the adjustment mechanism handle by changing the tightening torque of nut 3 of the axle fastening (replaceable head 13, ratchet wrench).
Check the operation of the steering column adjustment mechanism.
Install the transponder receiving coil in accordance with the requirements of paragraph. 5 real TI.
Install the upper and lower steering column covers and secure with two screws (torx T20 screwdriver).
Connect the ground wire terminal to the battery (spanner 10).
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.20, 1.19.21 in the scope of work performed.