Attention. Removal and installation of steering column switches is performed without removing the steering wheel.
Removal
Place the vehicle on the work post and apply the parking brake.
Turn the steering wheel towards the switch being removed and turn off the ignition (the operation is performed to provide access to the screws securing the switch through the upper opening of the steering wheel).
Loosen the two screws securing the steering column covers and, overcoming the force of the clamps, remove the upper and lower steering column covers (torx T20 screwdriver).
Attention: Before removing the windshield wiper mode switch, remove the transponder receiving coil from the ignition switch housing in accordance with the requirements of paragraph. 5 real TI.
Figure 4-1 - Removing the steering column switches: 1 - direction indicator and headlight switch; 2 - screws for fastening the turn signal and headlight switch; 3 - screws for fastening the windshield wiper mode switch; 4 - windshield wiper mode switch
Unscrew the two screws 2 or 3, Figure 4-1, fastenings, remove switch 1 or 4 from the switch block housing, disconnect the wiring harness connector from the switch and remove the switch (phillips screwdriver).
Installation
Connect the instrument panel harness connector to the switch.
Install the switch into the switch block housing and secure with two screws (phillips screwdriver).
Install, if removed, the transponder receiving coil in accordance with the requirements of paragraph. 5 real TI.
(Original text can be found on the website: www.LadaMan.ru)
Install the upper and lower steering column covers and secure with two screws (torx T20 screwdriver).
Turn on the ignition and check the operation of the steering column switches.
Present the vehicle to the Quality Control Department. The Quality Control Department will check the vehicle for compliance with the requirements of TU 017200-254-00232934, paragraphs 1.19.20, 1.19.21 in the scope of work performed.