1. Maintenance operations performed after the first 2500 km of a new vehicle:
Make sure that there are no extraneous noises or knocks when the engine is running.
Check the tightness of the fasteners of the power unit supports (see table 8.1.2).
Make sure there are no engine oil leaks through the engine seals and oil seals ("Checking the technical condition of the engine").
Replace engine oil and oil filter ("Engine Oil and Oil Filter - Replacement").
Check functionality (by the presence of fault codes) engine management systems ("Checking the technical condition of the engine management system").
Make sure there are no extraneous noises when engaging and disengaging the clutch ("Checking the technical condition of the clutch").
Adjust the thermal clearances in the valve timing mechanism ("Valve timing drive clearances - adjustment").
Check the clarity of gear shifting, make sure there are no extraneous noises or knocks when the gearbox is operating ("Checking the technical condition of the gearbox").
Make sure that there are no extraneous noises in the front wheel drive joints when the vehicle is moving in a straight line and when turning ("Checking the technical condition of the front wheel drives").
Make sure there are no extraneous noises in the front and rear suspensions when the car is moving over uneven surfaces! ("Checking the technical condition of the front suspension" and "Checking the technical condition of the rear suspension").
Check and, if necessary, adjust the wheel alignment angles ("Front wheel alignment angles").
Make sure the electric power steering is working properly ("Checking the technical condition of the steering").
Make sure there are no brake fluid leaks, check the condition of the hoses and tubes of the hydraulic brake system ("Checking the technical condition of the brake system").
Check and, if necessary, adjust the position of the brake light switch ("Brake Light Switch - Checking and Replacing").
Check the operation of the parking brake ("Checking the technical condition of the brake system").
Check the efficiency of all brake mechanisms ("Checking the technical condition of the brake system").
Check the brake fluid level in the master cylinder reservoir ("Brake fluid level in the master cylinder reservoir - checking").
Check the performance of the brake system hydraulic pressure regulator ("Rear Brake Fluid Pressure Regulator - Adjustment").
Check the functionality of the brake booster ("Vacuum brake booster - check").
Check the condition and tension of the alternator drive belt (for a car with a tensioner).
Make sure that the lighting system lamps, light signaling system and sound signal are in good working order ("Lighting, light and sound signaling").
Check the functionality of the headlight corrector.
Check and, if necessary, adjust the direction of the headlight beams ("Headlight unit - light adjustment").
2. After every 15,000 km of vehicle mileage, it is necessary to perform all operations (except those marked with "*") performed at 2,500 km mileage, as well as:
Check the tightness of the exhaust system and the condition of the muffler suspension parts ("Checking the technical condition of the exhaust system").
Check the condition and tension of the timing belt ("Timing Belt - Checking Condition", for engine without tensioner see. "Timing drive with tension roller", and if there is an automatic tensioner, see. "Timing belt drive with automatic tensioner").
Make sure there are no coolant leaks, check the condition of the hoses and radiator of the engine cooling system ("Checking the technical condition of the cooling system").
Check the coolant level in the expansion tank of the engine cooling system ("Checking the technical condition of the cooling system").
Check the tightness of fuel lines and hoses ("Checking the technical condition of the power supply system").
Check the amount of play in the steering ("Checking the technical condition of the steering").
Check the condition of the protective covers of the steering rods and steering gear ("Checking the technical condition of the steering").
Check the condition of the front and rear suspension parts ("Checking the technical condition of the front suspension" and "Checking the technical condition of the rear suspension").
Check the wear of the front brake pads ("Brake pads - checking for wear").
Make sure there are no transmission oil leaks through the gearbox seals and oil seals ("Checking the technical condition of the gearbox").
Check the gearbox oil level ("Gearbox - Checking the level and changing the oil").
Check the condition of the protective covers of the joint and the gear shift drive rod ("Gearshift Drive - Removal, Repair and Installation").
Check the degree of wear of the rear brake pads ("Brake pads - checking for wear") and lubricate the guide pins.
Check the condition of the protective covers of the front wheel drive joints ("Checking the technical condition of the front wheel drives").
Check the level and density of electrolyte in the battery ("Battery - Maintenance").
Make sure the generator is working properly ("Generator - check").
Check the serviceability of the windshield wipers and washers in all operating modes ("Windscreen wiper and washer").
Check the serviceability of the rear window heating.
Check the serviceability of the electric window lifts and outside mirrors.
Check the functionality of the electric seat heating (depending on the configuration).
Lubricate the hinges and door opening limiters ("Body maintenance").
Make sure that the door and hood locks are in good working order ("Checking the technical condition of the body"), seat mechanisms and seat belts.
Clean the drainage holes in the doors and sills ("Body maintenance").
Check the heater for proper operation ("Checking the technical condition of the ventilation and heating system").
Replace the filter element of the cabin ventilation system ("Cabin ventilation and heating filter - replacement").
3. After every 30,000 km of vehicle mileage, it is necessary to perform all operations (except those marked with "*") that are performed at every 15,000 km mileage, as well as:
Replace the fuel filter of the engine fuel system ("Fuel filter - replacement").
Replace the air filter element ("Air filter - replacing the filter element").
Replace spark plugs ("Spark plugs - replacement").
Clean and lubricate the battery terminals and posts ("Battery - Maintenance").
Article copied from the resource LADAMAN.RU
Lubricate the door and hood locks ("Body maintenance").
Check the condition of the tires and rims ("Checking the technical condition of wheels, tires and hubs").
Check and, if necessary, balance the wheels ("Checking the technical condition of wheels, tires and hubs").
Replace the alternator drive belt ("Generator Drive Belt - Replacement").
4. After every 45,000 km of vehicle mileage, it is necessary to perform all operations performed at every 15,000 km mileage, as well as:
Replace the brake fluid in the hydraulic brake system ("Hydraulic brake drive - brake fluid replacement").
Lubricate the hood lock drive cable ("Body maintenance").
5. After every 60,000 km of vehicle mileage, it is necessary to perform all operations that are performed at every 30,000 km mileage.
6. After every 75,000 km of vehicle mileage, it is necessary to perform all operations performed at every 15,000 km mileage, as well as:
Replace the timing belt (for a vehicle without a tensioner "Timing Belt - Replacement").
Change gearbox oil ("Gearbox - Checking the level and changing the oil").
Replace the coolant in the engine cooling system (or after three years, whichever comes first, "Coolant - Replacement").
Replace oxygen concentration sensors ("Oxygen Concentration Sensor - Checking and Replacing").
Note: Brake and coolant fluids must be replaced every three years if the vehicle's mileage during this period is less than the above. For the Gates PK 823 belt (catalog number 1118-1041020-07, which began to be installed in the generator drive without a tensioner since the end of 2011) it is possible that the manufacturer will increase the mileage between replacement periods.