Warning: To avoid damaging the ratchet mechanism, do not use ratchets to loosen and finally tighten bolts and nuts.
Since the car uses TORX bolts, as well as Allen bolts, the kit should include sets of corresponding heads and bits, as well as bits with a working profile for Phillips and slotted screwdrivers.
2. A ratchet with a hinge and a long handle. It is necessary for loosening large diameter threaded connections when significant effort must be applied (for example, when loosening the front wheel hub nut).
3. Set of combination wrenches (open-end and box-end wrenches) dimensions from 7 to 32 mm. It is desirable to have a full range of metric size keys available (through 1 mm).
Warning! Open-end wrenches are not intended to apply significant force to fasteners, as this will crush the edges of bolts and nuts. Tightening or loosening with such keys should only be done in cases where it is impossible to do so using socket or open-end wrenches.
4. Set of open-end wrenches. It is useful to supplement the set of combination wrenches with open-end curved wrenches of the most common sizes: 10, 12, 13, 15, 17, 19, 22 and 24 mm.
5. A set of Allen keys ranging in size from 2 to 12 mm.
6. Torque wrench. Designed for final tightening of threaded connections with a specified torque.
7. A set of Phillips and slotted screwdrivers, varying in size and length. It is very convenient if you have a large selection of screwdrivers with blades of different lengths and widths available when performing repairs.
8. Hammers. It is advisable to have several hammers with a steel striker weighing 200, 500, 1000 g, and, in addition, with a plastic or rubber striker.
9. Nippers (side cutters), combination pliers, flat-nose pliers.
10. Awl.
11. Soft metal punches (brass, copper, aluminum rods) for knocking out axles and shafts.
[Taken from the website: www.ladaman.ru]
12. A set of steel punches and drifts for knocking out pins, cotter pins, etc.
13. Chisel. It is better to buy two or three chisels with different blade widths. It is also advisable to have a long chisel for working in hard-to-reach places.
14. Hacksaw for metal, set of needle files and rasps.
15. Mounting blade. You should have a set of two or three blades of different lengths that can be used as levers.
16. Sliding pliers.
17. Metal brushes.
18. Electric drill with a set of metal drill bits (up to 0 13 mm).
19. Bench vice. The vice must be securely fastened to the workbench.