1. Engage 1st gear and place chocks under the front wheels. Remove the relevant wheel and brake pads from the vehicle.
2. From the back of the brake shield, clean the place where the brake pipe is attached and the wheel brake cylinder mounting bolts from dirt. To make it easier to loosen the rear wheel cylinder mounting bolts and brake pipe mounting nut, apply a special liquid such as WD-40 liquid wrench for threaded connections to the threaded connections.
3. Unscrew the nut securing the brake pipe to the wheel cylinder.
4. Disconnect the brake pipe from the wheel brake cylinder by plugging the hole in the brake hose, for example, with a bleed valve cap.
5. Remove the two wheel brake cylinder mounting bolts while holding it from the other side.
6. Remove the wheel cylinder from the brake shield.
7. Install the wheel brake cylinder on the vehicle in the reverse order of removal. After this, bleed the brake system on the car (only the wheel cylinder on the wheel being replaced is possible). Be sure to install the protective cap on the brake bleeder nipple.