1. Remove the appropriate wheel from the vehicle.
2. Remove the brake hose seal from the bracket on the strut.
3. Loosen the brake hose end on the wheel cylinder.
4. Bend back the tabs of the lock washers...
5. ... unscrew the two brake caliper mounting bolts, holding the guide pins by the hexagons with a second key, and remove the brake caliper assembly with the wheel brake cylinder.
6. Using a wrench, hold the brake hose tip by the hexagon and unscrew the brake caliper from the tip. Be careful: brake fluid will leak from the brake hose. Please note that there is a copper sealing ring on the brake hose tip. Replace the tightly compressed copper ring.
7. Clamp the brake caliper in a vice and remove the two Allen bolts securing the brake cylinder to the brake caliper. Remove the wheel brake cylinder from the caliper.
8. Install the wheel brake cylinder on the vehicle in the reverse order of removal. Before installation, lubricate the guide pins with UNIOL-1 grease, check the condition of the guide pin dust boots.
9. Bleed the brakes on the vehicle and check the efficiency of the braking system.
[Source link - website: ladaman.ru]